Reactive Diffusion Bonding Between Commercially Pure Titanium and 304 Stainless Steel Using Nickel Interlayer

Solid-State Diffusion Bonding of Commercially pure Titanium and Precipitation Hardening Stainless steel

Solid-state direct diffusion bonding of commercially pure Titanium (Cp-Ti) and precipitation hardening stainless steel (PHSS) has been carried out in the temperature range of 800°C to 1000°C with an interval of 50°C for 3.6 ks under 3.5 Mpa uniaxial load in (4 to 6)×10 Pa vacuum. The effects of temperatures have been investigated with reference to bond strength. The examination revealed that th...

Compressibility of 304 Stainless Steel Powder Metallurgy Materials Reinforced with 304 Short Stainless Steel Fibers

Powder metallurgy (P/M) technique is usually used for manufacturing porous metal materials. However, some P/M materials are limitedly used in engineering for their performance deficiency. A novel 304 stainless steel P/M material was produced by a solid-state sintering of 304 stainless steel powders and 304 short stainless steel fibers, which were alternately laid in layers according to mass rat...

Microstructure and mechanical properties evaluation of diffusion bonded joints of titanium to AISI 304 austenitic stainless steel

In this study, diffusion bonding between titanium and AISI 304 austenitic stainless steel by Ag interlayer was investigated. In order to carry out this research, samples prepared after surface preparation were placed inside the fixture and placed at the temperatures of 750,800 and 850 °C in the 30,60 and 90 min in the furnace under argon protective gas. The phase transformation and microstructu...

Microstructure and mechanical properties evaluation of diffusion bonded joints of titanium to AISI 304 austenitic stainless steel

In this study, diffusion bonding between titanium and AISI 304 austenitic stainless steel by Ag interlayer was investigated. In order to carry out this research, samples prepared after surface preparation were placed inside the fixture and placed at the temperatures of 750,800 and 850 °C in the 30,60 and 90 min in the furnace under argon protective gas. The phase transformation and microstructu...

Pain Evaluation Between Stainless Steel and Nickel Titanium Arches in Orthodontic Treatment — A Comparative Study