RE voSim: Organism‐level simulation of macro and microevolution
نویسندگان
چکیده
منابع مشابه
Diversification of the Salmonella Fimbriae: A Model of Macro- and Microevolution
Bacteria of the genus Salmonella comprise a large and evolutionary related population of zoonotic pathogens that can infect mammals, including humans and domestic animals, birds, reptiles and amphibians. Salmonella carries a plethora of virulence genes, including fimbrial adhesins, some of them known to participate in mammalian or avian host colonization. Each type of fimbria has its structural...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
simulation and design of electronic processing circuit for restaurants e-procurement system
the poor orientation of the restaurants toward the information technology has yet many unsolved issues in regards to the customers. one of these problems which lead the appeal list of later, and have a negative impact on the prestige of the restaurant is the case when the later does not respond on time to the customers’ needs, and which causes their dissatisfaction. this issue is really sensiti...
15 صفحه اولresponse articles: micro and macro analysis
the present study reports an analysis of response articles in four different disciplines in the social sciences, i.e., linguistics, english for specific purposes (esp), accounting, and psychology. the study has three phases: micro analysis, macro analysis, and e-mail interview. the results of the micro analysis indicate that a three-level linguistic pattern is used by the writers in order to cr...
15 صفحه اولSimulation and modeling of macro and micro components produced by powder injection molding: A review
During the recent years powder processing technologies have gained much attention due to the less energy consumption and recyclable powders. Manufacturing of complicated parts by the conventional powder metallurgy (PM) method is hard due to the uniaxial pressure, which leads to the low design flexibility. In order to prevail these constraints, powder injection molding (PIM) process, which inclu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Palaeontology
سال: 2019
ISSN: 0031-0239,1475-4983
DOI: 10.1111/pala.12420