Rapid Microfluidic Mixer Based on Ferrofluid and Integrated Microscale NdFeB-PDMS Magnet
نویسندگان
چکیده
منابع مشابه
A microfluidic chaotic mixer using ferrofluid
A novel micromixer which utilizes chaotic mixing induced by ferrofluid actuation is developed. The micromixer is fabricated by a polydimethylsiloxane micromolding technique. The micromixer consists of a T-shaped main mixing channel and two parallel sub-channels that intersect the main channel. Oscillation of a couple of ferrofluid slugs in the sub-channels, induced by external permanent magnet ...
متن کاملFunctional patterning of PDMS microfluidic devices using integrated chemo-masks.
Microfluidic devices can be molded easily from PDMS using soft lithography. However, the softness of the resulting microchannels makes it difficult to photolithographically pattern their surface properties, as is needed for applications such as double emulsification. We introduce a new patterning method for PDMS devices, using integrated oxygen reservoirs fabricated simultaneously with the micr...
متن کاملMicro magnetic stir-bar mixer integrated with parylene microfluidic channels.
Previously, we reported a micro magnetic stir-bar mixer driven by an external rotating magnetic field and its rapid mixing performance in polydimethyl-siloxane (PDMS) channels. The PDMS piece with embedded fluid channels were manually aligned to a glass substrate and assembled. In this paper, we report the fabrication and testing results of a micro magnetic stir-bar monolithically integrated in...
متن کاملNumerical analysis of a rapid magnetic microfluidic mixer.
This paper presents a detailed numerical investigation of the novel active microfluidic mixer proposed by Wen et al. (Electrophoresis 2009, 30, 4179-4186). This mixer uses an electromagnet driven by DC or AC power to induce transient interactive flows between a water-based ferrofluid and DI water. Experimental results clearly demonstrate the mixing mechanism. In the presence of the electromagne...
متن کاملRapid fabrication of microfluidic PDMS devices from reusable PDMS molds using laser ablation
The conventional fabrication methods for microfluidic devices require cleanroom processes that are costly and time-consuming. We present a novel, facile, and low-cost method for rapid fabrication of polydimethylsiloxane (PDMS) molds and devices. The method consists of three main fabrication steps: female mold (FM), male mold (MM), and chip fabrication. We use a CO2 laser cutter to pattern a thi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Micromachines
سال: 2019
ISSN: 2072-666X
DOI: 10.3390/mi11010029