R134a flow patterns in small-diameter tubes
نویسندگان
چکیده
منابع مشابه
Effect of Tube Diameter on Two-phase Flow Patterns in Mini Tubes
The effect of tube diameter on two-phase flow patterns was investigated in circular tubes with inner diameters of 0.6, 1.2, 1.7, 2.6, and 3.4mm using air and water. The gas and liquid superficial velocity ranges were 0.01–50 and 0.01–3m/s, respectively. The gas and liquid flow rates were measured and the two-phase flow pattern images were recorded using high-speed CMOS camera. The flow patterns...
متن کاملPulsatile flow patterns in distensible tubes.
• During the last fifty years a number of physical theories have been proposed in an attempt to describe analytically the behavior of pulsatile flow in the mammalian arterial system. In order to make such an approach to a system of nonuniform, viscoelastic vessels containing a non-Newtonian fluid at all possible, it becomes necessary to introduce simplifying assumptions, the judicious selection...
متن کاملEffect of Channel Roughness on Heat Transfer and Fluid Flow Characteristics at Low Reynolds Numbers in Small Diameter Tubes
The effect of roughness on pressure drop and heat transfer in circular tubes has been extensively studied in literature. The pioneering work of Nikuradse (1933) established the sand grain roughness as a major parameter in defining the friction factor during laminar and turbulent flows. Recent studies have indicated a transition to turbulent flows at Reynolds number values much below 2300 during...
متن کاملImprovement of 20 in. diameter photomultiplier tubes
The quality of the 20 in . photomultiplier tubes (Hamamatsu R1449) has been greatly improved over the required specifications for using them m the 50000 ton imaging water Cherenkov detector, Super-Kamiokande . In particular, the resolution of the timing response for single-photoelectron light has been reduced to 3 ns (1Q width), and a clear single-photoelectron peak can be seen in the pulse hei...
متن کاملMeasurement of Heat Transfer in the Entrance Region of Small Diameter Tubes
Heat transfer coefficient in the entrance region of water flowing through micro-tubes with diameters of 962 μm and 123 μm was investigated in this study. Two temperature measurement methods, thermocouple and liquid crystal thermography (LCT), were used to measure the tube surface temperature. The experimental data showed that the Nu in the entrance region can be predicted well by conventional c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
سال: 2005
ISSN: 0954-4089,2041-3009
DOI: 10.1243/095440805x7071