Quenching and Distortion*
نویسندگان
چکیده
Abstract This paper is based on a keynote lecture presented by Prof. Fechte-Heinen during the 2 nd International Conference Quenching and Distortion Engineering in April 2021. Firstly, it presents short summary of basics distortion formation. The mechanisms potential for with its carriers are discussed more detail. Furthermore, method explained. Finally, selected examples that illustrate connections between quenching process.
منابع مشابه
The QuenchMinerTM Expert System for Quenching and Distortion Control
The QuenchMinerTM Expert System is an enhancement over the original Web-based Data Mining tool developed at CHTE, WPI for analysis of quenching data. The goals of this Expert System are predicting results obtained under given quenching conditions, thereby supporting decision making to improve performance. It thus assists Heat Treating users. It is fed with the knowledge an expert has in the use...
متن کاملPressure-induced quenching of the Jahn-Teller distortion and insulator-to-metal transition in LaMnO(3).
LaMnO(3) was studied by synchrotron x-ray diffraction, optical spectroscopies, and transport measurements under pressures up to 40 GPa. The cooperative Jahn-Teller (JT) distortion is continuously reduced with increasing pressure. There is strong indication that the JT effect and the concomitant orbital order are completely suppressed above 18 GPa. The system, however, retains its insulating sta...
متن کاملEffects of Quenching and Partial Quenching on Penguin Matrix Elements
In the calculation of non-leptonic weak decay rates, a “mismatch” arises when the QCD evolution of the relevant weak hamiltonian down to hadronic scales is performed in unquenched QCD, but the hadronic matrix elements are then computed in (partially) quenched lattice QCD. This mismatch arises because the transformation properties of penguin operators under chiral symmetry change in the transiti...
متن کاملRemarks on Quenching 201 Quenching Occurs
Consider the parabolic problem u t div (a(u;ru)ru) = u p (1) for t > 0, x 2 R n under initial and boundary conditions u = 1, say. Since p is assumed positive, the right hand side becomes singular as u ! 0. When u reaches zero in nite or in nite time, one says that the solution quenches in nite or in nite time. This article gives a survey of results on this kind of problem and emphasizes those t...
متن کاملQuenching stress, quenching current and plastic strain in superconductors
mechanical stress and maximum superconducting current have been calculated for a superconductor subjected to uniform plastic deformation. The training effect due to strain hardening o f the material is discussed. These results are compared with an analogous case when the normal transition is caused by the thermo-magnetomechanical instability. The quenching current is shown to depend on the hist...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: HTM Journal of Heat Treatment and Materials
سال: 2021
ISSN: ['1867-2493', '2194-1831']
DOI: https://doi.org/10.1515/htm-2021-0017