Push-pull resonant DC-DC isolated converter
نویسندگان
چکیده
منابع مشابه
A novel resonant transition push–pull DC-DC converter
In hard-switched converters, the switching frequency is limited by switching losses and EMI problems. However, high-switching frequency is necessary to reduce the converter size. Hence, soft switching is imperative at high switching frequency to obtain good efficiency. Push–pull converter is a preferred topology at medium power level. This paper proposes a novel resonant transition topology for...
متن کاملIsolated Switched Boost Push Pull DC-DC Step-up Converter
An isolated switched high step up boost DC-DC converter is discussed in this paper. The main objective of this paper is to step up low voltage to very high voltage. This paper mainly initiates at boosting a 30V DC into 240V DC. The discussed converter benefits from the continuous input current. Usually, step-up DC-DC converters are suitable for input whose voltage level is very low. The circuit...
متن کاملA Three-Phase Current-Fed Push–Pull DC–DC Converter
In this paper, a new three-phase current-fed push– pull dc–dc converter is proposed. This converter uses a highfrequency three-phase transformer that provides galvanic isolation between the power source and the load. The three active switches are connected to the same reference, which simplifies the gate drive circuitry. Reduction of the input current ripple and the output voltage ripple is ach...
متن کاملHigh voltage gain DC-DC resonant converter
In this paper, a DC-DC resonant converter with high voltage gain and small size is studied. To reduce the size and weight of this converter, the operating frequency should be as high as possible. In this research, the frequency changes from 120 to 200 kHz. Due to the high operating frequency, it is necessary to reduce the switching losses using soft switching methods. Resonant converters are su...
متن کاملHigh voltage gain DC-DC resonant converter
In this paper, a DC-DC resonant converter with high voltage gain and small size is studied. To reduce the size and weight of this converter, the operating frequency should be as high as possible. In this research, the frequency changes from 120 to 200 kHz. Due to the high operating frequency, it is necessary to reduce the switching losses using soft switching methods. Resonant converters are su...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Polish Academy of Sciences: Technical Sciences
سال: 2013
ISSN: 0239-7528
DOI: 10.2478/bpasts-2013-0082