Push-out Test of Profiled Metal Decking Slabs with Cold-formed Steel Beams and Rebar Shear Connector
نویسندگان
چکیده
منابع مشابه
Local Buckling Tests on Cold-Formed Steel Beams
C and Z sections are two of the most common cold-formed steel shapes in use today. Accurate prediction of the bending performance of these sections is important for reliable and efficient cold-formed steel structures. Recent analytical work has highlighted discontinuities and inconsistencies in the American Iron and Steel Institute ~AISI! and Canadian Standards Association ~S136! design provisi...
متن کاملDistortional Buckling Tests on Cold-Formed Steel Beams
Failure in cold-formed steel beams is generally initiated by one of three instabilities: local, distortional, or lateral-torsional buckling. For cold-formed steel joists, purlins, or girts, when the compression flange is not restrained by attachment to sheathing or paneling, distortional buckling may be the predominant failure mode. Experimental results on cold-formed steel beams with unrestrai...
متن کاملOn Cold-Formed Steel Construction
Powder-actuated (also referred to as low velocity or powder-driven) fasteners are commonly used to attach cold-formed steel framing members, usually a track, to a concrete or structural steel support. Although commonly used, their behavior is less well understood than other fasteners such as screws, bolts and welds. The AISI Cold-Formed Steel Design Manual does not explicitly address powder act...
متن کاملDynamic fibre push-out test applied to metal-matrix composites
The dynamic fiber/matrix interface strength for a silicon-carbide-fiber-reinforced, titanium-alloy metal-matrix composite was measured by impacting the end of a fiber extending through a thin specimen with a diamond-tipped projectile at ~2 m/s. The matrix surrounding the distal end of the fiber was supported on the end of a Hopkinson bar fabricated from hypodermic needle tubing, and an interfer...
متن کاملTesting and numerical modelling of Steel-Concrete-Steel with stud bolts connectors subject to push-out loading
Steel-concrete-steel (SCS) sandwich panels are composed of two steel plates with low thicknesses and high densities and strengths and one thick layer between both plates with low strength and density known as core that is composed of concrete. Cohesive material-epoxy resin or shear connectors are usually used to connect the plates to the concrete core. SCS sandwich composites are being develope...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Walailak Journal of Science and Technology (WJST)
سال: 2021
ISSN: 2228-835X,1686-3933
DOI: 10.48048/wjst.2021.19825