PSPICE Hybrid Modeling and Simulation of Capacitive Micro-Gyroscopes
نویسندگان
چکیده
منابع مشابه
Modeling and Simulation of Broadband Rf Cavities in Pspice
Barrier bucket systems are planned for the SIS100 Synchrotron (part of the future accelerator facility FAIR) and the ESR storage ring to facilitate several longitudinal beam manipulations [1] [2]. In order to achieve a single-sine gap signal of the desired amplitude and quality, effects in the linear and nonlinear region of the RF systems have to be investigated and included in the design of th...
متن کاملPspice Simulation of Power Electronics Circuit And
This paper shows how power electronics circuits, electric motors and drives, can be simulated with modern simulation programs. The focus will be on PSpice, which is one of the most widely used general-purpose simulation programs. A simulation example is presented, and the results are compared with those obtained with Power System Simulation Tool based on Simulink.
متن کاملSimulation and Modeling of a High Sensitivity Micro-electro-mechanical Systems Capacitive Pressure Sensor with Small Size and Clamped Square Diaphragm
This paper proposes a Micro-electro-mechanical (MEMS) capacitive pressure sensor that relies on the movable electrode displaced like a flat plate equal to the maximum center deflection of diaphragm. The diaphragm, movable electrode and mechanical coupling are made of polysilicon, gold and Si3N4, respectively. The fixed electrode is gold and the substrate is Pyrex glass. This proposed method inc...
متن کاملModeling and simulation of Capacitive Micromachined Ultrasonic Transducer (CMUT)
This work presents the modeling and analysis of CMUT using the MEMS simulation software, Coventorware. A rectangular membrane CMUT of area 40μm X 20μm with 0.2μm thickness of silicon nitride as the movable membrane was designed. To reduce the parasitic capacitance, silicon substrate with gold was used as the fixed bottom electrode, and the combination of aluminium and chromium were used as top ...
متن کاملSimulation and modeling of macro and micro components produced by powder injection molding: A review
During the recent years powder processing technologies have gained much attention due to the less energy consumption and recyclable powders. Manufacturing of complicated parts by the conventional powder metallurgy (PM) method is hard due to the uniaxial pressure, which leads to the low design flexibility. In order to prevail these constraints, powder injection molding (PIM) process, which inclu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sensors
سال: 2018
ISSN: 1424-8220
DOI: 10.3390/s18041006