PROSES DEFORMASI SANGAT TINGGI (SEVERE PLASTIC DEFORMATION) TERHADAP PADUAN Al-5052 HASIL ANILING[Severe Plastic Deformation Process of Annealed Al-5052 Alloy]
نویسندگان
چکیده
منابع مشابه
Bonding Characteristics of Al and Al-Alloy Strips: Processed by Severe Plastic Deformation
In this paper, the study of efficient bonding characteristics of AA6014 and AA1050 metal strips is carried out for Accumulative Roll Bonding (ARB) process. Among various Severe Plastic Deformation (SPD) techniques, ARB process is widely used due to its ability to produce ultra-fine grained ( UFG) or nanostructured bulk material. It has been observed that, if the experimental pressure and corres...
متن کاملEBSD characterization of nano/ultrafine structured Al/Brass composite produced by severe plastic deformation
In the present work, nano/ultrafine structured Al/Brass composite was produced by accumulative roll bonding (ARB) up to eight cycles. The evolution of grain refinement and deformation texture and their effect on the mechanical properties were investigated. It was observed that by increasing the ARB cycles, due to the difference in flow properties of the metal constituents, brass layers necked, ...
متن کاملPLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملSevere Plastic Deformation of Metals
This paper provides an introduction in the field of severe plastic deformation (SPD). First of all the main methods to produce SPD materials are discussed. In the following section, the mechanisms leading to the formation of fine grains are reviewed and the influence of changes in strain path is highlighted. During post-SPD thermal annealing, some typical microstructural changes take place. The...
متن کاملNumerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metalurgi
سال: 2017
ISSN: 2443-3926,0126-3188
DOI: 10.14203/metalurgi.v27i3.229