Property and Oxidation Behaviours of (Mo,Cr)Si2 + ZrO2 Composite Produced by Pressure-Less Sintering
نویسندگان
چکیده
منابع مشابه
Dry Wear Behavior of 42CrMo4 Steel/ZrO2 Composite Prepared by Pressure-Less Infiltration Method
The aim of this research was to study the wear behavior of 42CrMo4 steel/ZrO2 composite with 10 and 30 ppi performed ceramic and compare it with the un-reinforced steel under different applied loads. The composite specimens were obtained by pressureless infiltration of the melt into a preformed ceramic of zirconium oxide. The effect of applied load on the specimens wear behavior was ...
متن کاملdry wear behavior of 42crmo4 steel/zro2 composite prepared by pressure-less infiltration method
the aim of this research was to study the wear behavior of 42crmo4 steel/zro2 composite with 10 and 30 ppi performed ceramic and compare it with the un-reinforced steel under different applied loads. the composite specimens were obtained by pressureless infiltration of the melt into a preformed ceramic of zirconium oxide. the effect of applied load on the specimens wear behavior was studied by ...
متن کاملPREPARATION AND SINTERING OF W-20%Wt Cu COMPOSITE POWDERS PRODUCED BY CO-PRECIPITATION METHOD
Abstract: materials can be fabricated by sintering of W-Cu composite powders. In this research W-20%wt Cu composite powderswas synthesized via a co-precipitation method. Precipitate obtained from a mixture of copper nitrate and ammoniumparatungstate (APT) in distilled water contained W-Cu compounds. This precipitate was washed, dried and calcinedat 550 of dried precipitate powder was determined...
متن کاملSintering Process and Mechanical Property of MWCNTs/HDPE Bulk Composite
Studies have proved that increasing polymer matrices by carbon nanotubes to form structural reinforcement and electrical conductivity have significantly improved mechanical and electrical properties at very low carbon nanotubes loading. In other words, increasing polymer matrices by carbon nanotubes to form structural reinforcement can reduce friction coefficient and enhance anti-wear property....
متن کاملSintering behaviour of composite materials borosilicate glass-ZrO2 fibre composite materials
The characteristics and properties of mixtures of a borosilicate glass and ZrO2 fibres obtained from compacts isothermally sintered are presented. Three different particle sizes of glass powder and different sintering temperatures and times have been used to reveal the influence of the specific surface area and the glass matrix viscosity on sintering. The fundamental developed aspects are the s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Science and Chemical Engineering
سال: 2016
ISSN: 2327-6045,2327-6053
DOI: 10.4236/msce.2016.47003