Properties of wrought Al-Zn-Mg alloys
نویسندگان
چکیده
منابع مشابه
CREEP AGE FORMING OF Al-Zn-Mg ALLOYS WITH OPTIMIZATION OF MECHANICALl PROPERTIES
Creep age forming (CAF) is one of the novel methods in aerospace industry that has been used to manufacture components of panels with improved mechanical properties and reduced fabrication cost. CAF is a combined age-hardening and stress-relaxation that are responsible for strengthening and forming, respectively. This paper deals with the experimental investigations of mechanical and springback...
متن کاملTHERMAL ANALYSIS AND KINETICS OF THE PRECIPITATION IN WROUGHT Al-Mg, Al-Mg-ScAND Al-Mg-Sc-Me (Me=Zr, Ti) ALLOYS
Precipitation behaviour of wrought Al-6Mg alloys with ternary scandium and quaternary zirconium and titanium has been studied. Hardness measurements and resistivity studies are employed to assess the precipitation behaviour of scandium doped Al-6Mg alloy without or with quaternary additions of zirconium and titanium. Further, the kinetics of precipitations are studied by differential scanning c...
متن کاملNeural network application for prediction mechanical properties of Mg-Al-Zn alloys
Purpose: The paper presents results of the research connected with the development of new approach based on the neural network to predict chemical composition and cooling rate for the mechanical properties of the Mg-Al-Zn cast alloys. The independent variables on the model are chemical composition of Mg-Al-Zn cast alloys and cooling rate. The dependent parameters are hardness, ultimate compress...
متن کاملMicrostructure of Al-Zn and Zn-Al Alloys*
The change of microstructure of the title alloys with concentration, temperature and applied thermal treatment was studied in situ by XRD. The alloys, having the Zn atomic fraction, x(Zn), from 0.03 to 0.62, were subjected to: (i) rapid quenching from a temperature, Tt, higher than the solid-solution temperature, Tss, in water at RT (samples WQ); (ii) slow cooling from Tt to RT (samples SC). Th...
متن کاملSynthesis and mechanical properties of nanostructured Mg-Al-Nd alloys
In this work, nanostructured Mg-Al-Nd alloys were successfully fabricated using mechanical alloying method. Phase structures of the milled powders and the extruded rods were examined using X-ray diffraction (XRD) and the microstructures were observed using a transmission electron microscope (TEM). The element distributions were also examined by an energy dispersive spectroscopy (EDS) system. Th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1971
ISSN: 0451-5994
DOI: 10.2464/jilm.21.702