Progressive failure analysis of three-dimensional woven carbon composites in single-bolt, double-shear bearing
نویسندگان
چکیده
منابع مشابه
Three–dimensional Stress Analysis of the T–bolt Joint
A three-dimensional finite element model of the joint has been developed. The model has been used to predict the stress field of the laminate in the joint area, assuming homogeneity and linear behavior of the material. The modeled geometry is a T-bolt that joins a coupon of glass fiber–epoxy and a block of steel. The results obtained from the model have been verified experimentally using both e...
متن کاملProcessing of Carbon Fiber Reinforced Composites by Three Dimensional Photolithography
The reinforcement of photoresins with continuous carbon fibers is discussed in this paper. The processing was conducted in an automated desktop photolithography unit (ADPU) developed and built in-house. Continuous fibers were added in situ to the photoresin to obtain composite samples containing over 20 vol% of the fibers. The tensile strength of these composites improved by at least a factor o...
متن کاملProgressive Damage Analysis of Laminated Composites using Continuum Damage Mechanics
In this paper, progressive damage and global failure of composite laminates under quasi-static, monotonic loading are investigated using 3D continuum damage mechanics. For this purpose, a finite element program has been developed using an eight-node 2D layered element including layer-wise plate theory. Damage analysis of a single orthotropic layer under various uniform in-plane and transverse l...
متن کاملShear deformation analysis for woven fabrics
A new mechanical model is proposed in this paper to evaluate the shearing properties for woven fabrics during the initial slip region. Compared to the existing mechanical model for fabric shear, this model involves not only bending but also torsion of curved yarns. This model has the advantage of taking into consideration the yarn undulation in fabrics while keeping mathematical rigor. Moreover...
متن کاملThree dimensional single-walled carbon nanotubes.
We report a simple fabrication method of creating a three-dimensional single-walled carbon nanotube (CNT) architecture in which suspended CNTs are aligned parallel to each other along the conventionally unused third dimension at lithographically defined locations. Combining top-down lithography with the bottom-up block copolymer self-assembly technique and utilizing the excellent film forming c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Composites Part B: Engineering
سال: 2016
ISSN: 1359-8368
DOI: 10.1016/j.compositesb.2015.08.082