Production performance of the ATLAS semiconductor tracker readout system
نویسندگان
چکیده
منابع مشابه
Diagnostic Analysis of Silicon Strips Detector Readout in the ATLAS Semi-Conductor Tracker Module Production
The ATLAS Semi-Conductor Tracker (SCT) Collaboration is currently in the production phase of fabricating and testing silicon strips modules for the ATLAS detector at the Large Hadron Collider being built at the CERN laboratory in Geneva, Switzerland. A small but relevant percentage of ICs developed a new set of defects after being mounted on hybrids that were not detected in the wafer screening...
متن کاملATLAS Silicon Microstrip Semiconductor Tracker (SCT)
The large hadron collider (LHC) is under construction at CERN, using the existing LEP tunnel of 27 km circumference, in order to accelerate protons to 7 TeV and to make head-on collisions at the center-of-mass energy of 14 TeV with a luminosity of 10 34 cm -2 s -1 [1]. The ATLAS detector, one of the two major general purpose detectors in LHC, was approved as an experiment in 1994 and is planned...
متن کاملperformance of biological system and advanced oxidation processes (aop) treating antibiotic production industrial wastewater
در این مطالعه، عملکرد دو سیستم اکسیداسیون شیمیایی پیشرفته و یک سیستم بیولوژیکی برای حذف آموکسی سیلین در فاضلاب های سنتزیدر غلظت های مشابه با موارد صنعتی مورد بررسی قرار گرفته شدند. مطالعه انجام شده دارای سه بخش متفاوت اکسیداسیون با ازن و اشعه uv، اکسیداسیون با استفاده از نانو فتوکاتالیست tio2 و استفاده از بیوراکتور هوازی لجن فعال با جداکننده های فیزیکی می باشد. در هر بخش، متغیر های متفاوتی متنا...
15 صفحه اولNoise Characterization of the ATLAS Tile Calorimeter Readout System
It is shown that the addition of a low pass RC filter to the current ATLAS Tile Calorimeter 3-in-1 card decreases the high frequency noise. A peak in the output voltage is found for 29 Mhz input noise but is filtered out by the same low pass filter.
متن کاملThe ATLAS ReadOut System - performance with first data and perspective for the future
The ATLAS ReadOut System (ROS) receives data fragments from ∼1600 detector readout links, buffers them and provides them on demand to the second-level trigger or to the event building system. The ROS is implemented with ∼150 PCs. Each PC houses a few, typically 4, custom-built PCI boards (ROBIN) and a 4-port PCIe Gigabit Ethernet NIC. The PCs run a multi-threaded object-oriented application man...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Nuclear Science
سال: 2006
ISSN: 0018-9499
DOI: 10.1109/tns.2006.874727