Production of Superplastic Aluminum Sheet Clad with Metal Matrix Composite by Hot Rolling

Magnificent Grain Refinement of Al-Mg2Si Composite by Hot Rolling

The effect of chemical composition and the hot rolling operations on the microstructure and mechanical properties of in situ aluminum matrix composite with Mg2Si phase as the reinforcement was studied. It was revealed that the modification by phosphorous results in the rounder (more spherical) primary and secondary (eutectic) magnesium silicide intermetallics. During hot rolling, the primary pa...

Study on Iraqi bauxite ceramic reinforced Aluminum metal matrix composite synthesized by stir casting

For the past decades researchers are showing immense interest to investigate the natural advantage of preparation of composites from minerals such as bauxite particles, and proved their effectiveness as cost effective reinforcing agents in fabrication of high performance composites. This study, is a new attempt in using the Iraqi natural bauxite powder with different proportions (2wt%, 4wt%, an...

Composite Aluminum-Copper Sheet Material by Friction Stir Welding and Cold Rolling

Process Simulation for Optimizing Superplastic Forming of Sheet Metal

Superplastic forming (SPF) is conducted in a heated, pressurized die where direct monitoring of critical SPF parameters is extremely difficult. Numerical models provide a critical means of tracking the forming process, allowing the applied gas pressure to be adjusted to maintain optimum SPF behavior throughout the forming process. This paper describes how the MARC finite element code was used t...

EFFECTS OF ELEVATED TEMPERATURE ON MECHANICAL BEHAVIOR OF AN ALUMINUM METAL MATRIX COMPOSITE

Effects of temperature on properties and behavior of a 20 vol % particulate SiC reinforced 6061 aluminum alloy and 6061 unreinforced Al alloy were investigated. Yield strength and elongation to failure were measured as a function of test temperatures up to 180^oC. In addition, the effects of holding time at 180^ oC on tensile properties and fracture mechanisms of the materials at this temperatu...