Process Variables Optimization in Lapping of EN8 Material Using Taguchi Method
نویسندگان
چکیده
منابع مشابه
Optimization of Edm Process Parameters Using Taguchi Method: a Review
Electrical discharge machining is assessed on the basis of Material Removal Rate (MRR), Tool Wear Rate (TWR), and Surface Roughness (SR). Process parameters that mostly affected the EDM Process are Pulse on Time, Pulse off Time, Discharge Current, Arc Gap and Duty Cycle. This paper reviews research for the optimization and improvement of various performance parameters measured in the experiment...
متن کاملParametric optimization of cylindrical grinding process through hybrid Taguchi method and RSM approach using genetic algorithm
The present investigation proposes a hybrid technique: Taguchi method, response surface methodology (RSM) and genetic algorithm (GA), to analyze, model and predict vibration and surface roughness in traverse cut cylindrical grinding of aluminum alloy. Experiments have been conducted as per L9 orthogonal array of Taguchi methodology using several levels of the grinding parameters. Analysis of va...
متن کاملParameter optimization by Taguchi Methods for finishing advanced ceramic balls using a novel eccentric lapping machine
The final finishing process of advanced ceramic balls used in hybrid precision bearings constitutes two thirds of the total manufacturing cost, hence the effective and economic finishing methods and processes are critical to their widespread application. A novel eccentric lapping machine is designed and manufactured, Hot Isostatically Pressed (HIPed) silicon nitride ball blanks (diameter 13.25 ...
متن کاملStudy of Effect of Spinning Process Variables on Fibre Length Parameters Using Taguchi Method
The effect of drafts at different stages of spinning process on fibre length distribution of slivers has been studied by using Taguchi Method and ANOVA technique. The L8 mixed orthogonal array was used to work out eight different slivers. Two different lap hanks, four different card drafts and two different draft/doublings at breaker and finisher were selected for the study. The fibrograph leng...
متن کاملOptimization of Process Parameters in Drilling of Smc Composites Using Taguchi Method
Original scientific paper This paper has presented and discussed machinability in the drilling of SMC (Sheet Mould Compound) A-Class composite materials using Taguchi's DoE method. The thrust forces, surface roughness and push-out peel-up delamination behaviour in drilling process for glass fibre reinforced SMC composites have been evaluated. The experimental results and the contribution ratio ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Mathematics
سال: 2018
ISSN: 2640-0855
DOI: 10.11648/j.engmath.20180201.15