Process Induced Skin-Core Morphology in Injection Molded Polyamide 66
نویسندگان
چکیده
منابع مشابه
Fiber Reinforcement Induced Warpage on Injection Molded Thermoplastics
1 Abstract The warpage characterizations of injection molded plastic parts are not standardized and very challenging due to its complex process. This paper presents a novel examination method of the deformation of injection molded plastic parts especially for fiber reinforced materials. A special, but simple part was introduced for the description of the effect of different technological parame...
متن کاملSynthesis and Characterization of Polyamide-66/Calcium Carbonate Composites
Polyamide-66(PA66)/CaCO3 micro- and nano-composites were prepared using a polymer solution method at filler loading of 0, 1, 2 and 3 weight percent. Nano-size of CaCO3 was synthesized by micro-emulsion technique. The material was characterized by XRD, SEM, FTIR and UV-VIS techniques. XRD results of composites suggested that CaCO3 particles are found in the amorphous phase of the semi-crystallin...
متن کاملInjection Molded Millimeter-Wave Horn Array Antenna
This paper shows injection molded millimeter-wave horn array antenna for the 1-dimensional APAA(Active Phase Array Antenna). The antenna is composed of horn antennas, grooved circular waveguide polarizers, E-plane T-junctions, and E-plane bends employing dielectric waveguides. This structure makes it possible to manufacture a feed circuit and radiating elements as an integrated unit by using in...
متن کاملThermal Processing of Injection-Molded Silicon Carbide
Silicon carbide is the most important and versatile non-oxide ceramic. Powder injection molding (PIM) is a method of high-speed fabrication of complex near-net shapes of SiC and other powders. Green micro-machining (GMM) is used to extend the shaping capability of green ceramics and powder metallurgy to smaller feature sizes. Debinding—removal of organic additives—is the rate-limiting step in P...
متن کاملInjection molded microfluidic chips featuring integrated interconnects.
An injection molding process for the fabrication of disposable plastic microfluidic chips with a cycle time of 2 min has been designed, developed, and implemented. Of the sixteen commercially available grades of cyclo-olefin copolymer (COC) that were screened for autofluorescence and transparency to ultraviolet (UV) light, Topas 8007 x 10 was identified as the most suitable for production. A ro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymers
سال: 2020
ISSN: 2073-4360
DOI: 10.3390/polym12040894