Process Development for Continnous Copper Smelting and Converting Process
نویسندگان
چکیده
منابع مشابه
The Aluminum Smelting Process
This introduction to the industrial primary aluminum production process presents a short description of the electrolytic reduction technology, the history of aluminum, and the importance of this metal and its production process to modern society. Aluminum's special qualities have enabled advances in technologies coupled with energy and cost savings. Aircraft capabilities have been greatly enhan...
متن کاملRecirculation of Chilean Copper Smelting Dust with High Arsenic Content to the Smelting Process
Most of the dust generated from the copper smelting process in Chili has been stored after the stabilization by hydrometallurgical process because it contains high concentration of arsenic. However, in recent years, the generation of dust has increased because of degrading the quality of concentrate. In addition, the environmental regulations become stricter. On the other hand, valuable metals ...
متن کاملThe Aluminum Smelting Process and Innovative Alternative Technologies
OBJECTIVE The industrial aluminum production process is addressed. The purpose is to give a short but comprehensive description of the electrolysis cell technology, the raw materials used, and the health and safety relevance of the process. METHODS This article is based on a study of the extensive chemical and medical literature on primary aluminum production. RESULTS At present, there are ...
متن کاملdirect smelting of steel: process simulation
the design and manufacture of direct smelting reactors depends on the rate of the physico-chemical reactions that occur in the particles immersed into the molten bath. investigation of the effects of the important parameters that influence the smelting rate of the particles that in the furnace are both difficult and expensive if the aimed is to take measure meuts under real practical conditions...
متن کاملCopper CMP and Process Control
A production worthy, copper CMP technology has been successfully developed on a multi-platen CMP system. The System consists of three polish platens, each of which is equipped with an optical endpoint detection system. The process consists of three steps with different polish slurries, and is designed to polish copper with a tantalum based barrier, and to achieve good defect performance. Patter...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1977
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.63.12_1911