Probabilistic evaluation of EMAR signals to evaluate pipe wall thickness and its application to pipe wall thinning management

monitoring of pipe-wall thickness and thinning rate by ultrasonic technique

an important issue in power generation and petrochemical industries is the monitoring of pipe wall thickness and corrosion/erosion rate. the pipes are usually subject to erosive and/or corrosive environments and any failure could be catastrophic. while periodic manual ultrasonic thickness measurement is the common practice in many industries, in certain cases, where higher accuracies are requir...

construction and validation of translation metacognitive strategy questionnaire and its application to translation quality

like any other learning activity, translation is a problem solving activity which involves executing parallel cognitive processes. the ability to think about these higher processes, plan, organize, monitor and evaluate the most influential executive cognitive processes is what flavell (1975) called “metacognition” which encompasses raising awareness of mental processes as well as using effectiv...

Wall corrections in modeling rotating pipe flow

Monitoring Pipe-Wall Corrosion Rate by Ultrasonic Technique

thickness and corrosion/erosion rate. In this thesis, a combination of signal processing techniques are used to estimate the corrosion rate estimates based on MBE. Corrosion rate is estimated based on ultrasonic pipe wall thickness data is collected over a short period of time using MBE model. This technique is based on data collected from the speedometer applied for thinning and both indicate ...

Failure pressure of straight pipe with wall-thinning under internal pressure

The failure pressure of pipe with wall-thinning was investigated by using three-dimensional elastic-plastic finite element analyses (FEA). With careful modeling of the pipe and flaw geometry in addition to a proper stress-strain relation of the material, FEA could estimate the precise burst pressure obtained by the tests. FEA was conducted by assuming three kinds of materials: line pipe steel, ...