PrintrLab incubator: A portable and low-cost CO2 incubator based on an open-source 3D printer architecture
نویسندگان
چکیده
منابع مشابه
Dimensional Error in Rapid Prototyping with Open Source Software and Low-cost 3D-printer
Rapid prototyping models (RPMs) had been extensively used in craniofacial and maxillofacial surgery, especially in areas such as orthognathic surgery, posttraumatic or oncological reconstructions, and implantology. Economic limitations are higher in developing countries such as Mexico, where resources dedicated to health care are limited, therefore limiting the use of RPM to few selected center...
متن کاملMagnetic field inhomogeneities due to CO2 incubator shelves: a source of experimental confounding and variability?
A thorough assessment of the static magnetic field (SMF) inside a CO2 incubator allowed us to identify non-negligible inhomogeneities close to the floor, ceiling, walls and the door. Given that incubator's shelves are made of a non-magnetic stainless steel alloy, we did not expect any important effect of them on the SMF. Surprisingly, we did find relatively strong distortion of the SMF due to s...
متن کاملan incubator model baSed on the territorial value chain
Policies to promote and encourage local foods may take many different shapes depending on both the specific targets and strategies. Some policies, especially at a local level, promote supply-chain vertical and horizontal integration as a comprehensive strategy which aims to help firms pursue several of the promoting policies. A business model that focuses its attention on the consumer of the pr...
متن کاملAn inexpensive and demountable walk-in incubator.
times after the incubator doors had been opened and closed (45 minutes to 45 hours), and in the centre of the highest and lowest shelf positions. The CO2 concentration varied between 31 % and 7-2 % and in practice a rate of between 20 and 60 ml per minute was found to support the growth of carbon dioxide requiring organisms such as newly isolated strains of N. gonorrhoeae and Br. abortus (inclu...
متن کاملA microperfused incubator for tissue mimetic 3D cultures.
High density, three-dimensional (3D) cultures present physical similarities to in vivo tissue and are invaluable tools for pre-clinical therapeutic discoveries and development of tissue engineered constructs. Unfortunately, the use of dense cultures is hindered by intra-culture transport limits allowing just a few layer thick cultures for reproducible studies. In order to overcome diffusion lim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: PLOS ONE
سال: 2021
ISSN: 1932-6203
DOI: 10.1371/journal.pone.0251812