Printing of Thin Walls using DMLS

Inkjet Printing onto Liquid Crystal Thin Films

Thin Domain Walls in Lyra Geometry

This paper studies thin domain walls within the frame work of Lyra Geometry. We have considered two models. First one is the thin domain wall with negligible pressures perpendicular and transverse direction to the wall and secondly, we take a particular type of thin domain wall where the pressure in the perpendicular direction is negligible but transverse pressures are existed. It is shown that...

3d Printing for Prototypes of Thin-film Pzt/polymer Microstructures

This work explores the viability of using 3D printing as a rapid-prototyping technique for microrobotic appendages made from thin-film PZT/polymer materials. First, the possibility of integrating piezoelectric materials into millimeter-scale (meso-scale) polymer melt-printed structures was investigated. Next, one specific robot limb geometry was chosen as a basis to compare structural modeling ...

Ink-jet printing of carbon nanotube thin film transistors

Ink-jet printing is an important process for placing active electronics on plastic substrates. We demonstrate ink-jet printing as a viable method for large area fabrication of carbon nanotube CNT thin film transistors TFTs . We investigate different routes for producing stable CNT solutions “inks” . These consist of dispersion methods for CNT debundling and the use of different solvents, such a...

The logarithmic tail of Néel walls in thin films