منابع مشابه
Pretreatment of Gray Cast Iron for Hard Chromium Electroplating (RESEARCH NOTES)
From the standpoint of processing, hard chromium layer plate may be applied to steels, cast iron, aluminum and nickel base alloys. Cast iron can be plated provided that the surface is capable of conducting the required current and is reasonably free of voids, pits, gross silicate inclusions, and massive segregation. There are many difficulties arising from graphite phase and deposition of hydro...
متن کاملChrome Electroplating Waste BAT
During the past several years, waste produced by the electroplating industry has attracted attention due to the level of pollutants found in the waste stream, the difficulty associated with treatment, and the cost of waste disposal. EPA has enacted regulations to control the discharge from plating facilities and estimates that 140 million lb of metal pollutants will be prevented from being disc...
متن کاملTreatment of Electroplating Wastes
~sing of the environment, the electroplating industry is likely to be one of the industries to be affected by the introduction of the water pollution control legislation in Hong Kong. The effect may be even more pronounced for the operators of small and medium-sized electroplating factories since they are unlikely to have any expertise in pollution control and will therefore require outside tec...
متن کاملNickel electroplating for nanostructure mold fabrication.
We demonstrated a practical process of fabricating nickel molds for nanoimprinting. Dual-side polished glass is chosen as the substrate on which nickel nanostructures are successfully electroplated. Photonic crystal structures with 242 nm diameters and other nanoscale pillars down to 9 nm diameters are achieved over a large area. The electroplating parameters are investigated and optimized. Thi...
متن کاملElectroplating of Ni4W
Nickel-tungsten alloys were electrodeposited on stationary working electrodes from a nickel sulfate, sodium tungstate, and tri-sodium citrate-based bath under different operating conditions. The microstructure of the deposits was studied by X-ray diffraction, the morphology by scanning electron microscopy and atomic force microscopy, and the approximate composition by energy dispersive spectros...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Jitsumu Hyomen Gijutsu
سال: 1986
ISSN: 1884-3417,0368-2358
DOI: 10.4139/sfj1970.33.286