PRESSURE TRANSIENT IN A PNEUMATIC VANE MOTOR
نویسندگان
چکیده
منابع مشابه
Design of a Hot Gas Vane Motor
This paper describes the design of a hot gas vane motor. The motor is intended as a portable direct drive actuator powered by a hot gaseous working fluid as an alternative to battery-powered electromagnetic motors. The objective is thus to convert a maximum amount of enthalpy at the inlet into mechanical rotational output energy in a compact and lightweight package. The described motor incorpor...
متن کاملOn the Observability of Pressure in a Pneumatic Servo Actuator
Pneumatic servo actuators are characterized by highly nonlinear dynamics from spool valve command to cylinder pressure, and as such are well suited to the use of nonlinear control methods requiring measurement of the full state, such as sliding mode control. This paper investigates the possibility of eliminating the pressure measurement required for nonlinear control in lieu of a nonlinear pres...
متن کاملVane Dynamics Analysis of a Tilted Vane Rotary Compressor
An analytical model of vane dynamics in a tilted vane rotary compressor is presented. With the geometric relationship of the vane in a tilted slot, and the roller, the kinetic equations were derived for evaluating the reciprocating inertial force of the vane, and the chamber volume equations were obtained for calculating pressure history inside the compression chamber. The empirical friction co...
متن کاملModelling, simulation and proportional integral control of a pneumatic motor
have shown a considerable amount of interest in the control of pneumatic drives over the past decade, for two main reasons, firstly, the response of the system is very slow and it is difficult to attain set points due to hysteresis and secondly, the dynamic model of the system is highly non-linear, which greatly complicates controller design and development. To address these problems, two strea...
متن کاملModelling and Control of a Pneumatic Motor Using Neural Networks
A considerable amount of interest has been shown by researchers in the control of pneumatic drives over the past decade, for two main reasons, firstly, the response is very slow and the inability to attain set points is high due to hystiresis and secondly, the dynamic model of the system is highly non-linear, which greatly complicates controller design and development. To address these problems...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the JFPS International Symposium on Fluid Power
سال: 1996
ISSN: 2185-6303
DOI: 10.5739/isfp.1996.355