منابع مشابه
Solidification in Square Section
The objective of the present work is to develop a numerical model to analyze melting solidification process considering the natural convection phenomena to an alloy metal in a square section. Physical medium is taken as incompressible Newtonian fluid with isotropy thermal properties where the heat is transferred by conduction and convection, including de thermal phase change phenomenon. The las...
متن کاملPressure Drop in Capsule Transporting Bends Carrying Spherical Capsules
One of the most important parameters in designing a capsule transporting pipeline is the pressure drop in the pipes carrying capsules and associated pipe fittings such as bends etc. Capsules are hollow containers with typically cylindrical or spherical shapes flowing in the pipeline along with the carrier fluid. The dynamic behavior of a long train of capsules depends on the behavior of each ca...
متن کاملLosses in single-mode silicon-on-insulator strip waveguides and bends.
We report the fabrication and accurate measurement of propagation and bending losses in single-mode silicon waveguides with submicron dimensions fabricated on silicon-on-insulator wafers. Owing to the small sidewall surface roughness achieved by processing on a standard 200mm CMOS fabrication line, minimal propagation losses of 3.6+/-0.1dB/cm for the TE polarization were measured at the telecom...
متن کاملMean square stability for Kalman filtering with Markovian packet losses
This paper studies the stability of Kalman filtering over a network subject to random packet losses, which aremodeled by a time-homogeneous ergodicMarkov process. For second-order systems, necessary and sufficient conditions for stability of the mean estimation error covariance matrices are derived by taking into account the system structure. While for certain classes of higher-order systems, n...
متن کاملOptimum Die Design in Drawing of Square Section Rod from Round Bar
Drawing of square section rod from round bar can be done with two die shapes. In the first die shape, deformation starts from corners of the square and in second die shape, deformation starts from sides of square. This article has compared the drawing force for both die shapes and as a result optimum die shape was determined. Due to complexity of metal flow inside the die, analyzing of actual p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
سال: 1981
ISSN: 0021-9592,1881-1299
DOI: 10.1252/jcej.14.173