PRESSURE LOSS AND LIQUID HOLDUP IN PACKED BED REACTOR WITH COCURRENT GAS-LIQUID DOWN FLOW

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Parameters characterising the pulsing flow for cocurrent flow of gas and foaming liquid in a pressurised trickle-bed reactor

The aim of the present work was to experimentally determine the parameters characterizing the pulse flow of liquids through bed i.e. the frequency of pulsation and the velocity of pulses travelling along the bed and next to work out the correlation equations enabling their assessment. The research was carried out in a pressure reactor (pressures up to 2 MPa) having 0.05 m in diameter and being ...

متن کامل

The Influence of Pressure on the Liquid Hold-up in a Cocurrent Gas-liquid Trickle-bed Reactor Operating at Low Gas Velocities

The influence of reactor pressure up to 6.0 MPa on the dynamic liquid hold-up in the trickle-flow regime with superficial gas velocities up to 5.2 cm/s has been investigated for water, ethanol and aqueous 40% ethyleneglycol, with nitrogen as the gas phase. Without gas flow, i.e. single-liquid trickle-flow operation, the reactor pressure has no influence on the dynamic liquid hold-up, which can ...

متن کامل

Effect of Pulsing on Reaction Outcome in a Gas-Liquid Catalytic Packed-Bed Reactor

There has been continuous interest and fascination with the fluid dynamics of trickle-beds (i.e., cocurrent gas-liquid packed-bed reactors) at least since Weekman and Myers (1964) first proposed a regime map for their operation. Consistent with other flow regime maps before (Baker, 1954; for gas-liquid pipe flow) and since (e.g., Mandhane et al., 1974; for pipe flow), visual observations were u...

متن کامل

Modeling of Fischer–tropsch Synthesis Packed Bed Reactor for Producing Liquid Fuels from Natural Gas

A tubular pilot scale fixed-bed reactor for the Fischer–Tropsch Synthesis (FTS) was simulated to numerically demonstrate the conversion of synthesis gas (CO+H2) to higher hydrocarbons over an iron based catalyst. The reactor was a 3.1 cm diameter and 2.75 m length steel tube. The feed temperature were between 563583 K. Saturated water was employed to control the peak temperature within the cata...

متن کامل

Automated medium–pressure modular liquid–gas reactor

This paper describes an automated reactor in which reactions can be carried out using at least one gaseous reagent and one liquid reagent at a pressure ofup to 5 bar. The reactor was used to produce a hydrogenation reaction, in which system all operations, i.e. introduction of liquids and gases, control and regulation of pressure, temperature and volume of gases introduced and finally draining ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: JOURNAL OF CHEMICAL ENGINEERING OF JAPAN

سال: 1973

ISSN: 0021-9592,1881-1299

DOI: 10.1252/jcej.6.147