Press Formability of an Inhomogeneous Sheet Metal
نویسندگان
چکیده
منابع مشابه
The Optimization of Servo Press Method for Sheet Metal Forming
Recently in the field of sheet metal forming, servo press, which can control the speed and position of the tool using a servo motor, is attractive method. Development process of servo press method is accelerated as the capacity of servo motor become bigger. In the future, it’s expected as a great alternative plan to replace conventional press method in order to improve quality, increase product...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملSheet Metal Bending: Forming Part Families for Generating Shared Press-Brake Setups
Sheet metal bending press-brakes can be setup to produce more than one type of part without requiring a setup change. To exploit this flexibility, we need setup planning techniques so that press-brake setups can be shared among many different parts. In this paper, we describe algorithms for partitioning a given set of parts into setup compatible part families that can be produced on the same se...
متن کاملTheoretical, Numerical and Experimental Investigation on Formability of Al3105-St14 Two-Layer Sheet
Two-layer metallic sheets have wide applications in various industries due to their superlative characteristics. This paper presents analytical model to investigate the formability of two-layer sheets based on Marciniak and Kuckzinsky (M-K) method using Barlat and Lian non-quadratic yield criterion. FEM simulation is also performed to calculate the forming limits based on bifurcation theory. Fo...
متن کاملTEXTURE AND PRESS FORMABILITY OF DUAL-PHASE STAINLESS STEEL SHEET, T. Goto, T. Kondoh, T. Sasaki, Y. Hirose, H. Inoue, pp. 269-274
The press formability of a dual-phase stainless steel sheet consisting of ferrite and austenite phases was estimated from a viewpoint of texture using plastic strain ratios (r-values). From the comparison of the mechanically obtained r-values by tensile test and the r-values calculated from the crystal orientation distribution functions (ODFs) of each phase, we found the ferrite phase contribut...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1975
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.41.1122