Preparation of Platinum Catalyst Layers for DMFC Cathodes by Pulsed Electrodeposition
نویسندگان
چکیده
منابع مشابه
Electrodeposition of platinum nanoparticles on reduced graphene oxide as an efficient catalyst for oxygen reduction reaction
Reduced graphene oxide film was synthesized on a glassy carbon electrode by electro reduction of graphene oxide powders in aqueous solution. Then platinum nano particles were deposited on reduced graphene oxide film that was deposited on the glassy carbon electrode via electro reduction of platinum salt. The Physical morphology of the platinum on reduced graphene oxide film was evaluated by sca...
متن کاملelectrodeposition of platinum nanoparticles on reduced graphene oxide as an efficient catalyst for oxygen reduction reaction
reduced graphene oxide film was synthesized on a glassy carbon electrode by electro reduction of graphene oxide powders in aqueous solution. then platinum nano particles were deposited on reduced graphene oxide film that was deposited on the glassy carbon electrode via electro reduction of platinum salt. the physical morphology of the platinum on reduced graphene oxide film was evaluated by sca...
متن کاملPulsed Electrodeposition of Copper
Pulsed electrolysis of copper has been systematically investigated by electrodepositing copper from a copper sulfate bath. Pulse duty cycles of 5 to 80 percent, at frequencies from 10 to 100 Hz with current densities ranging from 2.5 to 7.5 A/dm2 were employed. The appearance of Hull Cell panels with both direct current and pulsed current was recorded. The influence of pulsed current on current...
متن کاملDesign of ordered-catalyst layers for polymer electrolyte membrane fuel cell cathodes
In polymer electrolyte membrane fuel cells (PEMFCs), because the reaction rate in the cathode is slower than that in the anode, the cathode catalyst layers require more catalyst loading than the anodes [1]. Much research has been focused on improving the catalytic activity in cathodes and simultaneously reducing the amount of Pt supported by carbon black, which is the most commonly used cathode...
متن کاملPreparation of SOFC Anodes by Electrodeposition
Anodes for solid oxide fuel cells (SOFCs) have been prepared by electrodeposition of either Co or Ni into a layer of porous yttria-stabilized zirconia (YSZ), 60 μm thick. The YSZ, having 65% porosity, was prepared by tape casting with graphite pore formers and was attached to the dense YSZ electrolyte. After adding 10 vol % CeO2 by impregnation of aqueous solutions of CeNO3)3, followed by calci...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ECS Proceedings Volumes
سال: 2002
ISSN: 0161-6374,2576-1579
DOI: 10.1149/200231.0518pv