Preparation of metallocene thin film by dry process.
نویسندگان
چکیده
منابع مشابه
Dry and Wet Wear Characteristic of TiO2 Thin Film Prepared by Magnetic Sputtering in Ringer Solution
In this research, a thin film of TiO2 was applied on AZ91D using the method of magnetic sputtering. Microstructure investigations were done using field emission scanning electron microscope (FESEM) and X-ray diffraction (XRD). Wear resistance for the coating was investigated using the pin on the disk in the form of dry and in the Ringer's solution. After this test, the worn surface of the sampl...
متن کاملPreparation and growth of SnS thin film deposited by spray pyrolysis technique
In this paper thin films of tin sulfide (SnS) were deposited on the glass substrates using spray pyrolysis method with the substrate temperatures in the range of 400–600℃, keeping the other deposition parameters constant. In this work the characteristic of SnS thin films investigated. The XRD pattern and optical transmittance of thin films also are discussed. With the change in concen...
متن کاملProcess Optimization of Deposition Conditions for Low Temperature Thin Film Insulators used in Thin Film Transistors Displays
Deposition process for thin insulator used in polysilicon gate dielectric of thin film transistors are optimized. Silane and N2O plasma are used to form SiO2 layers at temperatures below 150 ºC. The deposition conditions as well as system operating parameters such as pressure, temperature, gas flow ratios, total flow rate and plasma power are also studied and their effects are discussed. The p...
متن کاملOxides and Thin Film Preparation Methods
In recent years, the demand for thin film coatings on large area substrates has been rapidly increasing. Coating is some times required to make an object harder, or to provide the surface with particular electrical and optical properties. Hence, research on thin film science has received much attention due to its tremendous applications in modern technology. The importance of coatings and the s...
متن کاملProcess compilation of thin film microdevices
This paper describes a systematic method for the automatic generation of fabrication processes of thin lm devices. The method uses a partially ordered set (poset) representation of device topology describing the order between its various components in the form of a directed acyclic graph. The sequence in which these components are fabricated is determined from the poset linear extensions, and t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON KAGAKU KAISHI
سال: 1987
ISSN: 2185-0925,0369-4577
DOI: 10.1246/nikkashi.1987.2013