Preparation of Aluminum Nitride Powder from Aluminum Chloride/Ethylenediamine Precursor.
نویسندگان
چکیده
منابع مشابه
Preparation of Γ-alumina from Aluminum Aminoalkoxides
The synthesis of materials with tailored properties is one of the most active areas of material science [1, 2]. Among so many materials, γ-alumina due to the significant application in catalysis, electronic and ceramic industry has been studied extensively [3]. Various processes have been employed for the preparation of high quality alumina, including sol-gel processing from aluminum alkoxides....
متن کاملDesign of Piezoelectric Aluminum Nitride MEMS Resonator
The following work reports the design, numerical, analytical and simulation characterization of an Aluminum Nitride MEMS resonator. The paper offers a comparison of rectangular plate MEMS resonator (length extensional and width extensional mode shapes) and ring shape MEMS resonator. It also demonstrates the contour Eigen modes of resonators and their equivalent electric circuit model (BVD). Fur...
متن کاملYellow electroluminescence from sputtering synthesized aluminum nitride nanocomposite thin film containing aluminum nanocrystals
In this work, visible electroluminescence (EL) from aluminum nitride (AlN) thin film containing aluminum nanocrystals (nc-Al) prepared by a radio frequency sputtering technique is reported. The yellow EL shows a spectrum peaked at 565 nm. A linear relationship between the EL and the current transport in the nc-Al/AlN nanocomposite thin film is observed, and both the current transport and the EL...
متن کاملDevelopment of Aluminum Nitride Single-Crystal Substrates
High-frequency, high-power semiconductor devices are widely used in electric vehicles, medical equipment, home appliances, and communication equipment. Recently, there has been a growing demand for semiconductors that have such characteristics as high withstand voltage, high speed and high-temperature operation, low power consumption and radiation resistance. To meet this demand, silicon carbid...
متن کاملAluminum Nitride Piezoelectric Micromachined Ultrasound Transducer Arrays
Air-coupled piezoelectric micromachined ultrasound transducer arrays, operating at ~190 kHz, have been fabricated utilizing an aluminum nitride piezoelectric layer. Improved fabrication processes have reduced the frequency variation seen in our previous work with single transducers resulting in arrays of transducers with resonant frequencies (fn) that match within the fractional half-power band...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2001
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.109.1272_709