Preparation and Analysis of Porous Oxychloride Titanium Oxide Precursor Material
نویسندگان
چکیده
منابع مشابه
Synthesis and photocatalytic activity of porous bismuth oxychloride hexagonal prisms.
Porous BiOCl hexagonal prisms have been successfully prepared through a simple solvothermal route. These novel BiOCl HPs with porous structures are assembled from nanoparticles and exhibit high activity and selectivity toward the photocatalytic aerobic oxidation of benzyl alcohol to benzaldehyde and degradation of methyl orange.
متن کاملNanostructured polymer–titanium composites and titanium oxide through polymer swelling in titania precursor
Polymer (XAD7HP)/Ti4+ nanocomposites were prepared through the swelling of polymer in titanium (IV) ethoxide as a titanium dioxide precursor. The nanocomposite beads exhibit relatively high porosity different than the porosity of the initial polymer. Thermal treatment of composite particles up to 200 °C in vacuum causes the change of their internal structure. At higher temperature, the componen...
متن کاملUltra-porous titanium oxide scaffold with high compressive strength
Highly porous and well interconnected titanium dioxide (TiO(2)) scaffolds with compressive strength above 2.5 MPa were fabricated without compromising the desired pore architectural characteristics, such as high porosity, appropriate pore size, surface-to-volume ratio, and interconnectivity. Processing parameters and pore architectural characteristics were investigated in order to identify the ...
متن کاملPreparation of Porous Carbon by Pyrolysis of Silylated Graphite Oxide
Starting from the graphite oxide silylated by 3-aminopropylmethyldiethoxysilane, porous carbons containing silica with layered structure were obtained. They possessed both microporosities and mesoporosities existing most likely between the carbon layers and the BET surface area reached 226 m/g. These types of carbons were obtained only when the silicon content in the initial silylated graphite ...
متن کاملPREPARATION OF CATALYTIC COATING OF TITANIUM OXIDE BY MEANS OF ELECTROLYTIC DEPOSITION
In the current research, the optimum conditions for the electrolytic deposition of TiO2 coatings on titanium pieces were experimentally investigated. Flat pieces of commercially available titanium with dimensions of 50 x20 x3 mm were used as the anode and cathode electrodes. The coatings were applied on the cathode in an electrolyte solution essentially from water and methanol, containing diffe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Mathematics and Physics
سال: 2019
ISSN: 2327-4352,2327-4379
DOI: 10.4236/jamp.2019.78108