PREMATURE SHUT OFF POSSIBILITY PREDICTION FOR AUTOMOTIVE FUEL TANK SYSTEM
نویسندگان
چکیده
منابع مشابه
3D Model of Fuel Tank for System Simulation
Engineering aircraft systems is a complex task. Therefore models and computer simulations are needed to test functions and behaviors of non existing systems, reduce testing time and cost, reduce the risk involved and to detect problems early which reduce the amount of implementation errors. At the section Vehicle Simulation and Thermal Analysis at Saab Aeronautics in Linköping every basic aircr...
متن کاملPerformance of Sulfonated Polyacrylamide/Chromium Triacetate Hydrogels for Water Shut-off Treatment
A hydrogel was prepared by crosslinking aqueous solutions of sulfonated polyacrylamide/chromium triacetate for use in water shut off operations. Gel swelling and the effects of salinity, injection time and flow rate on residual resistance factor (Frr) were investigated. In the presence of electrolytes, gel swelling decreased by about 80%. Results showed that oil permeability increased as inject...
متن کاملLife Cycle Design of a Fuel Tank System
This life cycle design (LCD) project was a collaborative effort between the National Pollution Prevention Center at the University of Michigan, General Motors (GM), and the U.S. Environmental Protection Agency (EPA). The primary objective of this project was to apply life cycle design tools to guide the improvement of fuel tank systems. Two alternative fuel tank systems used in a 1996 GM vehicl...
متن کاملCenter-Wing Fuel Tank Explosion
This report summarizes modeling studies supporting the second phase of quarter-scale testing for the NTSB investigation of the TWA Flight 800 accident. In this study, fuel-air tests were conducted to replicate earlier tests to assure repeatability of results. The quarter-scale test tank was redesigned to use heated Jet-A fuel/air mixtures at reduced ambient pressures. Although violent combustio...
متن کاملAutomotive Fuel Cell System simulation, component and compressor modelling
Future fuel cell (FC) systems for automotive applications will significantly depend on the development and realization of efficient and reliable components. The screw compressor for charging of the FC stack constitutes one important component in the system. In the European project NFCCPP (Numerical Fuel Cell Component Performance Prediction tool) within the EC 5 FP, a modular simulation environ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Revista de Engenharia Térmica
سال: 2021
ISSN: 1676-1790
DOI: 10.5380/reterm.v20i1.80445