Prediction of tensile power law creep constants from compression and bend data for ZrB2–20 vol% SiC composites at 1800 °C
نویسندگان
چکیده
منابع مشابه
Prediction of Creep Properties of Laminated Composites from Matrix Creep Data
ABSTRACT: A new model to predict the creep response oflaminated composite materials is presented. The correspondence principle is used to perform the microand macromechanics ana.Iysis in the Laplace domain. A new set ofmicromechanical formulas are used, which are accurate without the use of empirical correction factors. A macro-mechanical model is developed, which includes provisions for modeli...
متن کاملTensile Creep and Creep-Recovery Behavior of a SiC-Fiber─Si3N4-Matrix Composite
The tensile creep and creep-recovery behavior of a unidirectional Sic-fiher/Si,N,-matrix composite was investigated at 1200°C in air. A primary objective of the study was to determine how various sustained and cyclic creep loading histories would influence the creep rate, accumulated creep strain, and the amount of strain recovered upon specimen unloading. The key results obtained from the inve...
متن کاملOXIDATION OF C/SiC COMPOSITES AT REDUCED OXYGEN PARTIAL PRESSURES
T-300 carbon fibers and T-300 carbon fiber reinforced silicon carbide composites (C/SiC) were oxidized in flowing reduced oxygen partial pressure environments at a total pressure of one atmosphere (0.5 atm O2, 0.05 atm O2 and 0.005 atm O2, balance argon). Experiments were conducted at four temperatures (816°, 1149°, 1343°, and 1538°C). The oxidation kinetics were monitored using thermogravimetr...
متن کاملTensile Stress Acoustic Constants of Unidirectional Graphite/Epoxy Composites
Previously, the stress acoustic constants (SAC's) of unidirectional graphite/epoxy composites were measured to determine the nonlinear moduli of this material. These measurements were made under compressive loading in order to obtain the sufficient number of values needed to calculate these moduli. However, because their strength in tension along fiber directions can be several times greater, m...
متن کاملOxidation of ZrB2-SiC Composites at 1600 °C: Effect of Carbides, Borides, Silicides, and Chopped Carbon Fiber
The aim of this work is to optimize the oxidation resistance of ZrB2-SiC-based composites with different additives. Effect of nine factors including SiC, Cf, MoSi2, HfB2 and ZrC contents, milling time of Cf (M.t) and SPS parameters such as temperature, time and pressure on oxidation resistance in four levels was investigated. Taguchi design was applied to explore effective parameters for ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Advanced Ceramics
سال: 2017
ISSN: 2226-4108,2227-8508
DOI: 10.1007/s40145-017-0242-4