Prediction of Penetration in Welded Joints by Welding Conditions (Part II)
نویسندگان
چکیده
منابع مشابه
Flexural Strength Improvement of Welded Joints Prepared by Vibratory Welding Process
including translation into other languages reserved by the publisher. No part of this journal may be reproduced or used in any form or by any means without written permission from the publisher, except for noncommercial, educational use including classroom teaching purposes. Product or company names used in this journal are for identification purposes only. Inclusion of the names of the product...
متن کاملFatigue Behaviour Study of Laser Hybrid Welded Eccentric Fillet Joints – Part Ii: State-of-the-art of Fracture Mechanics and Fatigue Analysis of Welded Joints
Simplified fatigue and fracture mechanics based assessment methods are widely used by the industry to determine the structural integrity significance of postulated cracks, manufacturing flaws, service-induced cracking or suspected degradation of engineering components under normal and abnormal service loads. In many cases, welded joints are the regions most likely to contain original fabricatio...
متن کاملFatigue Life Prediction for Welded Joints with Known Initial Crack
The inspection of various structures often detects a fatigue cracks developed during long service life. These fatigue cracks significantly reduce remaining fatigue life and fatigue strength. Influence of the initial fatigue cracks size in non-load-carrying fillet-welded one-sided transverse attachment joints on the remaining fatigue life and fatigue strength is considered in this paper. A compu...
متن کاملEvaluation Of Mechanical Properties Of Dissimilar Metal Tube Welded Joints Using Inert Gas Welding
Evaluation of welding process such as metal inert gas welding and tungsten inert gas arc welding on tensile, bend and hardness properties of austenitic stainless steel SS347H(18Cr 10Ni 1Cb ), T22(21⁄4Cr Mo) and T91(9Cr 1Mo V) grades are studied. Tubes of 54 mm of outer diameter and 4 mm of wall thickness is used as a base material in the following combination SS347H VS T91 and T91 VS T22 is wel...
متن کاملThe Effect of Welding Energy on the Microstructural and Mechanical Properties of Ultrasonic-Welded Copper Joints
The effects of welding energy on the mechanical and microstructural characteristics of ultrasonic-welded pure copper plates were investigated. Complex dynamic recrystallization and grain growth occurred inside the weld zone during ultrasonic welding. At a low welding energy, a thin band of straight weld interfaces was observed and had an ultra-fine grain structure. With an increase in welding e...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1956
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.25.18