Prediction of Martensite Start Temperature for Lightweight Fe-Mn-Al-C Steels
نویسندگان
چکیده
منابع مشابه
Fe–Al–Mn–C lightweight structural alloys: a review on the microstructures and mechanical properties
Adding a large amount of light elements such as aluminum to steels is not a new concept recalling that several Fe-Al-Mn-C alloys were patented in 1950s for replacement of nickel or chromium in corrosion resistance steels. However, the so-called lightweight steels or low-density steels were revisited recently, which is driven by demands from the industry where steel has served as a major structu...
متن کاملMartensite in Steels
The name martensite is after the German scientist Martens. It was used originally to describe the hard microconstituent found in quenched steels. Martensite remains of the greatest technological importance in steels where it can confer an outstanding combination of strength (> 3500MPa) and toughness (> 200MPam 1 2 ). Many materials other than steel are now known to exhibit the same type of soli...
متن کاملCritical Assessment : Martensite – Start Temperature for the γ → ε Transformation
It is increasingly important in the context of high–manganese steels of the kind that lead to twinning–induced plasticity to be able to estimate the temperature at which ε–martensite forms when austenite is cooled. We find that the thermodynamic method used in similar calculations for α martensite cannot in many cases be implemented because of apparently imprecise thermodynamic data, a conclusi...
متن کاملKinetics of Austenite Recrystallization during the Annealing of Cold-rolled Fe-Mn-Al-C Steel
In the current study, the recrystallization behavior of 75% cold-rolled Fe-22Mn-10Al-1.4C steel during annealing at 750, 770, 790, 810, and 830°C was studied. X-ray diffraction patterns and optical microscopy were used to characterize microstructures. The Vickers Micro-hardness test was used to characterize recrystallization kinetics during annealing. Johnson-Mehl-Avrami-Kolmogorov (JMAK) model...
متن کاملUncertainties in dilatometric determination of martensite start temperature
Methods for the dilatometric determination of the martensite start temperature of steels are discussed, with emphasis on noise in the experimental data. The methods are tested on a new set of experiments using a specially prepared steel. Relying on the first detection of expansion due to transformation is fraught with difficulties. Instead, an offset method is proposed which should enable indep...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Phase Equilibria and Diffusion
سال: 2018
ISSN: 1547-7037,1863-7345
DOI: 10.1007/s11669-018-0660-1