Prediction for Flow Stress of 95CrMo Hollow Steel During Hot Compression
نویسندگان
چکیده
منابع مشابه
Effect of Changing Strain Rate on Flow Stress during Hot Deformation of Type 316L Stainless Steel
In industrial rolling, changes in strain rate and temperature occur with strain during passes, and between one pass and the next. Plane strain compression testing has been used with ramped changes in strain rate during deformation, and with changes in strain rate between two deformations to study their effects on flow stress. No systematic deviations from a mechanical equation of state were fou...
متن کاملa study of the flow behaviour of a nb-v-ti microalloyed steel during hot compression test
the flow stress of steel depends significantly on microstructural changes taken place during hot deformation processes. in hot deformation processes, the flow stress of steel is influenced by two main metallurgical phenomena, i.e. recovery and recrystallization, along with its chemical composition and thermo-mechanical parameters. the final mechanical properties of steel are also determined by ...
متن کاملEVALUATING HOT DEFORMATION BEHAVIOR OF W360 TOOL STEEL BY HOT COMPRESSION TEST
In this research, the hot deformation behavior of W360 tool steel was investigated using hot compression test at 1000-1200°C and strain rates of 0.001, 0.01, 0.1, and 1 s-1. According to the results, dynamic recrystallization was found the most important restoration factor of this alloy during hot deformation. Recrystallization was enhanced with an increase in temperature and strain rate. Also,...
متن کاملFE-Based Analysis of Hot Forming Process Using the Flow Stress Prediction Model
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...
متن کاملFE-Based Analysis of Hot Forming Process Using the Flow Stress Prediction Model
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Metallurgica Sinica (English Letters)
سال: 2016
ISSN: 1006-7191,2194-1289
DOI: 10.1007/s40195-016-0498-7