Predicting the pore-filling ratio in lumen-impregnated wood
نویسندگان
چکیده
منابع مشابه
Handling of impregnated waste wood and characterization of ash residues after combustion of the wood
In the next ten years the amounts of waste wood impregnated with Cu, Cr and As (CCA) is expected to increase dramatically world wide. CCA has been widely used for wood preservation since the early 1950s and because the fixation of CCA in the wood is good, the concentration of CCA is still high, when the wood is at the end of service. In some countries e.g. Denmark and Norway, the use of As for ...
متن کاملA modified squeeze equation for predicting the filling ratio of nanoimprint lithography
A numerical method using the modified squeeze model is proposed in this paper in order to overcome the limitation of the established squeeze equation and obtain filling ratios for nanoimprint lithography (NIL). Because the imprinting velocity is overestimated when the ratio of indenter width to polymer thickness is close to unity, the modified equation is critical. For verification, the numeric...
متن کاملWood energy: predicting costs.
1389 C R E D IT : B E R N D T H IS S E N /D P A /C O R B IS Wood Energy: Predicting Costs THE POLICY FORUM “WOOD ENERGY IN America” (D. deB. Richter Jr. et al., 13 March, p. 1432) was a much-needed and long-overdue contribution to energy discussions. However, fossil fuels are not four times more expensive than wood per unit energy. Rather, most fossil fuels are still less expensive than wood in...
متن کاملSolid-ionic liquid interfaces: pore filling revisited.
The properties of ionic liquids on ordered and non-ordered mesoporous silicas (silica gel, MCM-41, SBA-15) were studied by nitrogen sorption, mercury intrusion and thermogravimetric analyses, as well as (129)Xe-NMR spectroscopy. The ionic liquids investigated are based on the 1-hexyl-3-methylimidazolium cation, which was combined with anions of low (bis(trifluoromethanesulfonyl)imide; [NTf2](-)...
متن کاملElectron-Beam Curing of Acrylate/Nanoparticle Impregnated Wood Products
This study investigated the feasibility of using an electron beam (EB) process to cure chemically impregnated wood products. Maple wood planks were impregnated with the low-viscosity resins 1,6 hexanediol dimethacrylate (HDDA) and trimethylolpropane trimethacrylate (TMPTA). The addition of nanoparticles into the formulation was also studied. The impregnated wood was then cured by EB irradiation...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Wood Science and Technology
سال: 2017
ISSN: 0043-7719,1432-5225
DOI: 10.1007/s00226-017-0933-6