Predicting the Performance of Gorgan Wastewater Treatment Plant Using ANN-GA, CANFIS, and ANN Models
نویسندگان
چکیده
منابع مشابه
Evaluation of ANN-BP and ANN-GA Models Performance in Predicting Mechanical Properties and Machinability of Cast Copper Alloys
In this paper artificial neural network (ANN) models were developed to predict the mechanical properties and machinability of Cu–Sn–Pb–Si–Ni– Fe–Zn–Al alloys on the basis of the chemical composition (wt%) of alloying elements. The multi-layer perceptron architecture was used for developing ANN models. Two ANN training approaches, namely, the classical gradient descent back propagation (BP) and ...
متن کاملImproving the performance of financial forecasting using different combination architectures of ARIMA and ANN models
Despite several individual forecasting models that have been proposed in the literature, accurate forecasting is yet one of the major challenging problems facing decision makers in various fields, especially financial markets. This is the main reason that numerous researchers have been devoted to develop strategies to improve forecasting accuracy. One of the most well established and widely use...
متن کاملSimulation of groundwater quality parameters using ANN and ANN+PSO models (Case study: Ramhormoz Plain)
One of the main aims of water resource planners and managers is to estimate and predict the parameters of groundwater quality so that they can make managerial decisions. In this regard, there have many models developed, proposing better management in order to maintain water quality. Most of these models require input parameters that are either hardly available or time-consuming and expensive to...
متن کاملSimulation of groundwater quality parameters using ANN and ANN+PSO models (Case study: Ramhormoz Plain)
One of the main aims of water resource planners and managers is to estimate and predict the parameters of groundwater quality so that they can make managerial decisions. In this regard, there have many models developed, proposing better management in order to maintain water quality. Most of these models require input parameters that are either hardly available or time-consuming and expensive to...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Avicenna Journal of Environmental Health Engineering
سال: 2019
ISSN: 2423-4583
DOI: 10.34172/ajehe.2019.12