منابع مشابه
LASER CUTTING PARAMETERS The laser cutting parameters are dependent on the beam characteristics, the cutting rate
The laser cutting parameters are dependent on the beam characteristics, the cutting rate required, the composition and thickness of the material to be cut, and the desired cut edge quality. The laser cutting process and cut quality depend upon the proper selection of laser and workpiece parameters. Deficiencies in cutting quality may be related to the slow process drifts and disturbances that a...
متن کاملLaser Beam Hazard for flight personnel
Lasers can produce a beam of light of such intensity that permanent damage to human tissue, in particular the retina of the eye, can be caused instantaneously, even at distances of over 10 km. At lower intensities, laser beams can seriously affect visual performance without causing physical damage to the eyes; causing transient damage or causing sensation and loss of focus. Laser illumination o...
متن کاملAiry beam laser.
A method to design lasers that emit an arbitrary beam profile is studied. In these lasers, output-coupling is performed by a diffraction grating that imposes a phase and amplitude distribution onto the diffracted light. A solid-state laser emitting beams with a two-dimensional Airy intensity profile is demonstrated both theoretically and experimentally. In this case, the diffraction grating add...
متن کاملAtomic laser-beam finder.
We report on an experimental method to align a laser beam to a cloud of atoms trapped in a magneto-optical trap (MOT). We show how balanced lock-in detection leads to a very sensitive method to align the laser beam to the atoms in the plane perpendicular to the propagation direction. This provides a very reliable and fast way of aligning laser beams to atoms trapped in a MOT.
متن کاملNumerical simulation of laser beam welding of Ti6Al4V sheet
This paper was aimed to report the 3D finite element analysis simulation of laser welding process of Ti6Al4V 1.7 mm sheets in butt joint in order to predict the temperature distribution, hardness, and weld geometry. The butt-joint welds were made using CO2 laser with the maximum power of 2.2 kW in the continuous wave mode. A part of the experimental work was carried out to verify the weld geome...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Laser Technik Journal
سال: 2012
ISSN: 1613-7728
DOI: 10.1002/latj.201290006