Predicting inter-phase mass transfer for idealized Taylor flow: A comparison of numerical frameworks
نویسندگان
چکیده
منابع مشابه
A Mass Conservative Method for Numerical Modeling of Axisymmetric flow
In this paper, the cell-centered finite volume method (CC-FVM) has been presented to simulate the axisymmetric radial flow toward a pumping well. The model is applied to the unstructured triangular grids which allows to simulate inhomogeneous and complex-shaped domains. Due to the non-orthogonality of the irregular grids, the multipoint flux approximation (MPFA) methods are used to discretize t...
متن کاملNumerical Investigation of Turbulent Mass Transfer in a 90° Bend
This paper presents a numerical study of local mass transfer coefficients in a 90° bend using the RNG version of k–e model to include the influence of curvature on the turbulent transport. Simulations were performed for flow through a 90°, 3-D bend for Reynolds numbers of 13500, 90000, and 390000, Schmidt numbers of 2.53 and 700 and curvature ratios of 1.5, 2, and 2.5. The differences betwe...
متن کاملNumerical Simulation of Drop Coalescence in the Presence of Inter-Phase Mass Transfer
Contents Introduction: Drop coalescence and applications; Effect of inter-phase mass transfer. • Inter-phase transport of solutes-convection-diffusion equations in the phases. Numerical method: • Boundary Integral Method for the Stokes equations in the drops; • Finite Difference Method for the flow in the film and the convection-diffusion equations.
متن کاملHydromagnetic Taylor–Couette flow: numerical formulation and comparison with experiment
Taylor–Couette flow in the presence of a magnetic field is a problem belonging to classical hydromagnetics and deserves to be more widely studied than it has been to date. In the nonlinear regime the literature is scarce. We develop a formulation suitable for solution of the full three dimensional nonlinear hydromagnetic equations in cylindrical geometry, which is motived by the formulation for...
متن کاملSubcooled two-phase flow boiling in a microchannel heat sink: comparison of conventional numerical models
Subcooled flow boiling in multi-microchannels can be used as an efficient thermal management approach in compact electrical devices. Highly subcooled flow boiling of HFE 7100 is studied in two microchannel heat sinks to choose a proper numerical model for simulating boiling flows in microchannels. Results of five different numerical models, including Volume of Fluid (VOF), Eulerian boiling, Eul...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chemical Engineering Science
سال: 2011
ISSN: 0009-2509
DOI: 10.1016/j.ces.2011.01.046