Precision Micro-Welding Using Single-Mode Fiber Laser
نویسندگان
چکیده
منابع مشابه
Laser beam shaping using a single-mode fiber abrupt taper.
A new beam-shaping device was realized by an abrupt taper with a length of approximately 700 microm and a waist of approximately 40 microm. The insertion loss of the device is less than 3%. The diameter of the flat beam top can be up to approximately 900 microm with a small intensity variation (4%) and a small half-divergence angle (2.5 degrees). The conversion efficiency of the new device from...
متن کاملHigh-Precision Characterization of Single-Mode Optical Fiber Arrays
A precise method of measuring core center dispersion in single-mode fiber arrays is presented. This approach dispenses with the use of high-precision linear translation stages and is based on a direct comparison of the fiber core center position to a simple lithographically patterned template. Combining image recognition and efficient processing algorithm, the fiber-core center positions of fib...
متن کاملFemtosecond fiber laser welding of dissimilar metals.
In this paper, welding of dissimilar metals was demonstrated for the first time, to the best of our knowledge, by using a high-energy high-repetition-rate femtosecond fiber laser. Metallurgical and mechanical properties were investigated and analyzed under various processing parameters (pulse energy, repetition rate, and welding speed). Results showed that the formation of intermetallic brittle...
متن کاملFiber Laser Coherent Array for Power Scaling of Single-Mode Fiber Laser
Coherent beam combining of many fiber lasers by the Y-shaped complex resonator method realizes both power scaling and spectral narrowing. The basic characteristics of this Y-shaped coherent array, scalability of power summation, and bandwidth narrowing property are presented. As high as 85% addition efficiency with only a few longitudinal-modes was obtained in an array of eight 10-nm bandwidth ...
متن کاملLaser Induced Damage Reduction in Single-Mode Fiber Devices
We propose ihe use of tapered-up structures such as the fiber-horn lens and the straight-tip fiberhorn lens to be integrated in single-mode fiber devices to raise the damage threshold for input power. The optical damage limit with the use of such structures in single mode fibers is studied in this work. It is observed that for these devices to be practical, special attention needs to be put in ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of High Temperature Society
سال: 2004
ISSN: 0387-1096
DOI: 10.7791/jhts.30.55