Precise adhesive bonding for electronics equipments.
نویسندگان
چکیده
منابع مشابه
Transition from analogue-to-digital nuclear electronics for precise gamma radiation spectroscopy: advantages and limitations
In this paper, digital signal processing for precise gamma ray spectroscopy is presented. The basis of this system is a 14bit waveform digitizer which samples the output of pre-amplifier signals directly. The advantages and limitations of the digital spectrometer compared with analog spectrometer has been tested and analyzed from precise gamma ray spectroscopy point of view. The results shows t...
متن کاملAdhesive bonding of composites
provision of large, stress-bearing area excellent fatigue strength good shock absorption reduced galvanic corrosion no need to have access to far-side of adherend to make joint bonding is possible on dissimilar materials provision of smooth contours and sections around joint areas sealing improved damping which increases structural stiffness reduction in distortion and metal...
متن کاملAdhesive Bonding of Wood Materials
Adhesion to Wood 9–1 Surface Properties of Wood Adherends 9–2 Extractives on Surfaces 9–3 Knifeand Abrasive-Planed Surfaces 9–3 Veneer Surfaces 9–4 Surfaces of Wood and Nonwood Composite Products 9–5 Physical Properties of Wood Adherends 9–6 Density and Porosity 9–6 Moisture Content and Dimensional Changes 9–7 Adhesives 9–9 Composition 9–9 Health and Safety 9–10 Strength and Durability 9–10 Adh...
متن کاملPhotochemical tissue bonding with chitosan adhesive films
BACKGROUND Photochemical tissue bonding (PTB) is a promising sutureless technique for tissue repair. PTB is often achieved by applying a solution of rose bengal (RB) between two tissue edges, which are irradiated by a green laser to crosslink collagen fibers with minimal heat production. In this study, RB has been incorporated in chitosan films to create a novel tissue adhesive that is laser-ac...
متن کاملBonding Durability of Four Adhesive Systems.
OBJECTIVES This study aimed to compare the durability of four adhesive systems by assessing their microtensile bond strength (MTBS) and microleakage during six months of water storage. MATERIALS AND METHODS A total of 128 human third molars were used. The adhesives tested were Scotch Bond Multipurpose (SBMP), Single Bond (SB), Clearfil-SE bond (CSEB), and All-Bond SE (ABSE). After sample prep...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1986
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.52.255