Precipitation and Shape Recovery in CuAlNi+TiB Alloy
نویسندگان
چکیده
منابع مشابه
Transformation-Induced Creep and Creep Recovery of Shape Memory Alloy
If the shape memory alloy is subjected to the subloop loading under the stress-controlled condition, creep and creep recovery can appear based on the martensitic transformation. In the design of shape memory alloy elements, these deformation properties are important since the deflection of shape memory alloy elements can change under constant stress. The conditions for the progress of the marte...
متن کاملPrecipitation and Thermal Fatigue in Ni-Ti-Zr Shape Memory Alloy Thin Films by Combinatorial nanoCalorimetry
Thin-film samples of Ni-Ti-Zr shape memory alloys were studied by combinatorial nanocalorimetry to determine the effects of high-temperature (900°C) heat treatments and lowtemperature (450°C) thermal cycling on the characteristics of the martensite transformation. The response of the samples to heat treatments depends on composition and is controlled by a precipitation mechanism. Two precipitat...
متن کاملShape recovery of shape memory alloy fiber embedded resin matrix smart composite after crack repair.
Ni-Ti shape memory alloy fiber embedded resin matrix composites were produced for evaluation of "smart denture", a newly developing denture with the function to close its own crack. Their bending strength and shape recovery after instant crack repair was estimated. The embedded fibers did not decrease the bending strength of the composite after repair. The crack closure of the composites was pe...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Le Journal de Physique IV
سال: 1995
ISSN: 1155-4339
DOI: 10.1051/jp4:1995230