Pre-evaluation on surface profile in turning process based on cutting parameters
نویسندگان
چکیده
منابع مشابه
Optimization of Cutting Parameters in Turning Process
Predicting the main cutting force during turning is of great importance as it helps in setting the appropriate cutting parameters before machining starts.Again, optimization of cutting parameters is one of the most important elements in any process planning of metal parts as economy of machining operation plays a key role in gaining competitive advantage. This paper presents an experimental stu...
متن کاملOptimization of Process Parameters based on Surface Roughness and Cutting Force in MQL Turning of AISI 4340 using Nano Fluid
The aim of this research work is focused on optimization of process parameters under Minimum Quantity Lubrication (MQL) using nano fluid in turning of AISI 4340. A study of effect of process parameters in turning of AISI 4340 under MQL condition with nano fluid (Multiwalled Carbon Nano Tube) on the cutting force generated and machined surface roughness is carried out. In the experiment conducte...
متن کاملOptimization of Cutting Parameters for Surface Roughness in Turning
The optimized cutting parameters are very important to control the required surface quality. In the present study, Taguchi method is used to find the optimal cutting parameters for surface roughness (Ra) in turning. The L-18 orthogonal array, the signal-to-noise ratio & analysis of variance are employed to study the performance characteristics in turning operations of AISI-410 steel bars using ...
متن کاملEffect of cutting parameters on tool-chip interface temperature in an orthogonal turning process
The aim of this paper is to investigate the effect of cutting speed and uncut chip thickness on cutting performance. A Finite Element Method (FEM) based on the ABAQUS explicit software which involves Johnson-Cook material mode and Coulombs friction law was used to simulate of High Speed Machining (HSM) of AISI 1045 steel. In this simulation work, feed rate ranging from 0.05 mm/rev to 0.13 mm/re...
متن کاملEffect of Cutting Parameters on MRR and Surface Roughness in Turning EN-8
Surface finish is one of the prime requirements of customers for machined parts. The present paper presents an experimental study to investigate the effects of cutting parameters like spindle speed, feed and depth of cut on surface finish and material removal rate on EN-8. Taguchi methodology has been applied to optimize cutting parameters. The results showed that the spindle speed (the most si...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The International Journal of Advanced Manufacturing Technology
سال: 2009
ISSN: 0268-3768,1433-3015
DOI: 10.1007/s00170-009-2417-9