Practical formula for root bending stress of helical gears.
نویسندگان
چکیده
منابع مشابه
An Investigation of the Influence of Shaft Misalignment on Bending Stresses of Helical Gears with Lead Crown
Introduction Gears are highly engineered machine elements that must be designed not only to meet the torque, speed, life and noise requirements under nominal conditions, but also to compensate for adverse effects due to manufacturing errors, variations and elastic deformations of the support structures. In addition to the elastic deformation of the support and structures, manufacturing errors i...
متن کاملBending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملCooling and Lubrication of High-speed Helical Gears
Centrifugal compressor and turbine manufacturers are building machines that operate at increasingly higher speeds to reduce the size and cost of their equipment. Helical gears are commonly used to step down the speed of these machines to match nominal motor and generator speeds. The demand for higher compressor and turbine speeds has resulted in an increase in the maximum pitch line velocities ...
متن کاملProduct Evaluation In Elliptical Helical Pipe Bending
This research proposes a computation approach to address the evaluation of end product machining accuracy in elliptical surfaced helical pipe bending using 6dof parallel manipulator as a pipe bender. The target end product is wearable metal muscle supporters used in build-to-order welfare product manufacturing. This paper proposes a product testing model that mainly corrects the surface directi...
متن کاملHelical Quantum Edge Gears in 2D Topological Insulators.
We show that two-terminal transport can measure the Luttinger liquid (LL) parameter K, in helical LLs at the edges of two-dimensional topological insulators (TIs) with Rashba spin-orbit coupling. We consider a Coulomb drag geometry with two coplanar TIs and short-ranged spin-flip interedge scattering. Current injected into one edge loop induces circulation in the second, which floats without le...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1986
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.52.1979