منابع مشابه
Flexible Power Electronic Transformer for Power Flow Control Applications
This paper proposes a Flexible Power Electronic Transformer (FPET) for the application in the micro-grids. The low frequency transformer is usually used at the Point of Common Coupling (PCC) to connect the low voltage grid and utility network to each other. The conventional 50Hz transformer results in enhanced low voltage-grid power management system during grid-connected operation. In this pap...
متن کاملRecent Power Transformer Technology
Power transformers are essential components of substation equipment for the efficient and stable operation of electric power systems. There is demand for transformers with lower price and higher reliability. In addition, depending upon the onsite conditions, such as narrow roads, mountainous areas or highly congested urban areas, harmony with the surrounding environment is required throughout s...
متن کاملPower Transformer Incipient Faults Monitoring
Power transformers are important and expensive components in the electric power system. The knowledge of the actual status of the transformer insulation behavior, load tap changer performance, temperature, and load condition is necessary in order to evaluate the service performance concerning reliability, availability and safety. Systems abnormalities, loading, switching and ambient condition n...
متن کاملCMOS compatible transformer power combiner
Introduction: Power amplifiers are a key building block in any radio transceiver, usually necessitating a multi-chip module solution owing to the requirement of a specialised process with high voltage breakdown and low-loss passive components. Several researches have demonstrated that CMOS technology is a viable option for implementation of the power amplifier. Fully integrated transformer base...
متن کاملCost-Constrained Selection of Strand Wire and Number in a Litz-Wire Transformer Winding
Design of litz-wire windings subject to cost constraints is analyzed. An approximation of normalized cost is combined with analysis of proximity effect losses to find combinations of strand number and diameter that optimally trade off cost and loss. The relationship between wire size, normalized cost, and normalized loss is shown to have a general form that applies to a wide range of designs. A...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Asian Education Studies
سال: 2016
ISSN: 2424-9033,2424-8487
DOI: 10.20849/aes.v2i1.112