Power Parameters and Efficiency of Class B Audio Amplifiers in Real-World Scenario
نویسندگان
چکیده
منابع مشابه
Efficiency of Low Power Audio Amplifiers and Loudspeakers
In this paper we look at the load presented to audio amplifiers by real transducers. We consider the power losses in Class-AB and Class-D amplifier topologies, and determine that in order to predict efficiency it is necessary to consider the amplifier/transducer combination. The ability of the class-D amplifier to recycle quadrature load current offers new ways to improve efficiency. INTRODUCTI...
متن کاملEfficiency of low power audio amplifiers and loudspeakers
In this paper we look at the load presented to audio amplifiers by real transducers. We consider the power losses in Class-AB and Class-D amplifier topologies, and determine that in order to predict efficiency it is necessary to consider the amplifier/transducer combination. The ability of the class-D amplifier to recycle quadrature load current offers new ways to improve efficiency. INTRODUCTI...
متن کاملVariable-Voltage Class-B Power Amplifiers
The Class-E power amplifier is widely used due to its high efficiency, resulting from switching at zero voltage and zero slope of the switch voltage. In this paper, we extend general analytical solutions for the Class-E power amplifier to the ideal single-ended Variable-Voltage Class-E (Class-Evv) power amplifier that switches at zero slope but not necessarily at zero voltage. The theory is ver...
متن کاملDesign of High Efficiency Class E Power Amplifiers
This paper presents a new procedure to design of high efficiency class E power amplifiers (PAs) using nonlinear transistors. The active device (MESFET-ATF34143) has been investigated and load harmonic networks have also been designed to match the requirement. By using the new procedure, the power added efficiency (PAE) of PAs could be increased to over 70%. The effect of the stabilized resistor...
متن کاملClass of High-Efficiency Tuned Switching Power Amplifiers
The previous literature on tuned power amplifiers has not made clear the fundamental differences between amplifiers in which the output device acts 1) as a current source, or 2) as a switch. Previous circuits have often operated in contradiction to their design assumptions, resulting in the need for “cut-and-try” design. The new class of amplifiers deseribed here is based on a load network synt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Radioengineering
سال: 2017
ISSN: 1210-2512
DOI: 10.13164/re.2017.0258