Power loss reduction in electronic inverters trough IGBT-MOSFET combination
نویسندگان
چکیده
منابع مشابه
Protection Strategies for IGBT Current Source Inverters
An overview of overcurrent and overvoltage CSI faults is presented and strategies, how to protect a CSI equipped with IGBT power switches against these failures are developed and explained. The shown strategies and the related circuits are applicable at low expense and require only minor changes in the CSI and its control.
متن کاملCryo-MOSFET and IGBT : a Comparison
The prefened device for power eletronics in the multi-kilowatt 1300-1000 V range is today the IGBT (Insulated Gate Bipolar Transistor). It may in the near future see an emerging strong competitor for certain suitable applications: The Cryo-MOSFET. This paper compares the main properties of these two devices. It demonstrates that the Cryo-MOSFET in combination with high-temperature superconducto...
متن کاملExplosion proof housings for IGBT module based high power inverters in HVDC transmission application
Worldwide many attempts are taken to improve lifetime and power cycling capability of wire bonded IGBT modules. But even in very conservative inverter designs overload conditions may occur and cause damage to the inverter. In addition it is a fact that even the best design will reach its "end of life"
متن کاملA model reduction approach for constructing compact dynamic thermal models of IGBT-modules of inverters
This paper presents a model reduction approach for constructing lumped RC thermal networks of IGBTmodules of inverters for which heat and subsequent temperature increases vary with time on different scales ranging from nanosecond to second. It was observed that the time-dependent heat and temperature profiles of transistors and diodes of IGBT-modules of inverters oscillate at two frequencies, o...
متن کاملA Novel and Simple Current Controller for Three-Phase IGBT PWM Power Inverters
A new feedback current controller for three-phase pulse with modulated power inverters is presented. It is based on a current loop with two non linear three-level hysteresis controllers. The voltage vectors applied to the load are accurately selected in order to minimise the output current error. Controller structure based on simple analog-digital hardware implementation is shown and experiment...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Earth and Planetary Science
سال: 2009
ISSN: 1878-5220
DOI: 10.1016/j.proeps.2009.09.237