Power-Flattening Method for Boiling Water Reactor
نویسندگان
چکیده
منابع مشابه
Advanced Power Plant Modeling with Applications to an Advanced Boiling Water Reactor and a Heat Exchanger
Advanced methods that use continuity wave equations in fluid flow paths and exact solutions of these and all other differential equations are applied to transient performance models of a counter flow heat exchanger and an Advanced Boiling Water Reactor (ABWR). The continuity wave equations for single and two-phase flow, with heat addition, are developed, and the exact solution for a typical lea...
متن کاملNeural Network Controller for the Pressurized Water Reactor Power Control
Although there have been some severe nuclear accidents such as Three Mile Island (USA), Chernobyl (Ukraine) and Fukushima (Japan), nuclear fission energy is still a source of clean energy that can substitute fossil fuels in a centralized way and in a great amount with commercial availability and economic competitiveness. Since the pressurized water reactor (PWR) is the most widely used nuclear ...
متن کاملRTC-method for the control of nuclear reactor power
In this paper, a new concept of the Reactivity Trace Curve (RTC) for reactor power control is presented. The concept is demonstrated for a reactor model with one group of delayed neutrons, where the reactivity trace curve is simply a closed form exponential solution of the RTC-differential equation identifier. An extended reactor model of multigroup (six groups) of delayed neutrons is discussed...
متن کاملA lattice Boltzmann framework to simulate boiling water reactor core hydrodynamics
This paper presents a consistent LBM formulation for the simulation of a two-phase water–steam system. Results of initial model validation in a range of thermodynamic conditions typical for BoilingWater Reactors (BWRs) are also shown. The interface between the two coexisting phases is captured from the dynamics of the model itself, i.e., no interface tracking is needed. The model is based on th...
متن کاملREACTOR PHYSICS CALCULATIONS ON MOX FUEL IN BOILING WATER REACTORS (BWRs)
The loading of MOX (Mixed Oxide) fuel in BWRs (Boiling Water Reactors) is considered in this paper in a “once-through” strategy. The fuel assemblies are of the General Electric 8×8 type, whereas the reactor is of the General Electric BWR/6 type. Comparisons with traditional UOX (Uranium Oxide) fuel assemblies revealed that the loading of MOX fuel in BWRs is possible, but this type of fuel creat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nuclear Science and Technology
سال: 1981
ISSN: 0022-3131,1881-1248
DOI: 10.1080/18811248.1981.9733232