Power factor improvement on LED lamp driver using BIFRED converter
نویسندگان
چکیده
منابع مشابه
An Isolated Off-Line High Power Factor Electrolytic Capacitor-Less LED Driver with Pulsating Output Current
One of the most efficient lighting technology is based on light-emitting diodes (LEDs). Common LED drivers with AC-input (50-60Hz) usually require a bulk electrolytic capacitor to decrease low-frequency ripple in the output. However, the critical element that limits the lifespan of the LED driver is the electrolytic capacitor. An isolated off-line LED driver is proposed in this paper, in which ...
متن کاملAnalysis and Design of the Integrated Double Buck-Boost Converter as a High-Power-Factor Driver for Power-LED Lamps
The IDBB converter features just one controlled switch and two inductors and is able to supply a solid-state lamp from the mains providing high power factor and good efficiency. And with a careful design of the converter the filter capacitances can be made small enough so that film capacitors may be used. Thus the converter mean time between failures can be made as high as that of the solid-sta...
متن کاملA Single-Stage LED Tube Lamp Driver with Power-Factor Corrections and Soft Switching for Energy-Saving Indoor Lighting Applications
Abstract: This paper presents a single-stage alternating current (AC)/direct current (DC) light-emitting diode (LED) tube lamp driver for energy-saving indoor lighting applications; this driver features power-factor corrections and soft switching, and also integrates a dual buck-boost converter with coupled inductors and a half-bridge series resonant converter cascaded with a bridge rectifier i...
متن کاملMulti-Lamp High-Power-Factor Electronic Ballast Using a Fixed-Frequency Self-Oscillating Driver
This paper presents a fixed-frequency self-oscillating high-power-factor electronic ballast supplying four independent lamps. The fixed-frequency self-oscillating driver is achieved adding a LC series filter supplying a small resistor. The primary winding of the self-oscillating transformer is the series inductor of the filter. So, if one or more lamps are damaged, the switching frequency will ...
متن کاملPower Factor Improvement Using Single Phase Bridgeless Cuk Converter Topology Based on Fuzzy Logic Control
This paper deals with a new Cuk Topology for Power Factor Correction (PFC). Most of the front-end PFC converters are implemented using diode bridge and this results in the lower efficiency due to significant losses with reduced power factor. This new Cuk converter is a bridgeless Cuk PFC converter with two semiconductors switches. The current flow path in converter during each interval of the s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TELKOMNIKA (Telecommunication Computing Electronics and Control)
سال: 2020
ISSN: 2302-9293,1693-6930
DOI: 10.12928/telkomnika.v18i1.13160