Possibilities of precision material micro-processing by laser pulse copper-vapor radiation
نویسندگان
چکیده
منابع مشابه
Ultrafast laser material processing using dynamic temporal pulse shaping
Phase manipulated ultrafast laser pulses and temporally tailored pulse trains with THz repetition rates are promising new tools for quality micromachining of brittle dielectric materials, allowing to adapt the energy delivery rate to the material properties for optimal processing quality. The sequential energy delivery with judiciously chosen pulse trains may induce softening of the material du...
متن کاملcontrol of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولEradication of angiolymphoid hyperplasia with eosinophilia by copper vapor laser.
A healthy 47-year-old white woman presented with 4 vascular-appearing plaques on the left upper part of the forehead (Figure 1A), which had been present for approximately 9 years. On physical examination, there was a 1.031.2-cm pink plaque with 3 similar-appearing papules above it measuring 0.4 to 0.8 cm. One lesion extended into the hairline. Two 3-mm punch biopsy specimens were obtained, whic...
متن کاملModulated Laser Pulse based Water Vapor DIAL
A single pulse modulation and pseudorandom coded pulse modulation are utilized for water vapor DIAL in this paper. The water vapor profiles conducted from these modulation techniques are compared to the real observation data in summer in Japan. As a result, the single pulse modulation is appropriate for near region measurement, while pseudorandom coded pulse modulation is appropriate for far re...
متن کاملAbsorption measurements of carbon monoxide laser radiation by water vapor.
An intracavity water vapor cell in conjunction with a CO laser was used to measure experimentally the absorptive losses introduced for nineteen of the laser emission lines. The results indicated that the existing theoretical models are inadequate for predicting actual absorptance values for water vapor partial pressures in excess of 100 Torr. The accepted spectral location of at least one water...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science intensive technologies in mechanical engineering
سال: 2017
ISSN: 2223-4608
DOI: 10.12737/24550