PORTABLE WIND TURBINES USES BLADE TYPE INVERSE TAPER
نویسندگان
چکیده
منابع مشابه
Inverse Design of Blade Shapes for Vertical Axis Wind Turbines
An inverse design process is applied to determine blade shapes used in vertical axis wind turbines (VAWTs). The method is based on the modified Garabedian-McFadden technique that uses the deviation of the pressure distribution or the velocity distribution on the surface from a target pressure or velocity distribution, and modifies the blade surface in order to reduce this deviation. The method ...
متن کاملTwo LQRI based Blade Pitch Controls for Wind Turbines
As the wind turbine size has been increasing and their mechanical components are built lighter, the reduction of the structural loads becomes a very important task of wind turbine control in addition to maximum wind power capture. In this paper, we present a separate set of collective and individual pitch control algorithms. Both pitch control algorithms use the LQR control technique with integ...
متن کاملIntegrated airfoil and blade design method for large wind turbines
This paper presents an integrated method for designing airfoil families of large wind turbine blades. For a given rotor diameter and tip speed ratio, the optimal airfoils are designed based on the local speed ratios. To achieve high power performance at low cost, the airfoils are designed with an objective of high Cp and small chord length. When the airfoils are obtained, the optimum flow angle...
متن کاملPerformance improvement of a wind turbine blade using a developed inverse design method
The purpose of this study is to improve the aerodynamic performance of wind turbine blades, using the Ball-Spine inverse design method. The inverse design goal is to calculate a geometry corresponds to a given pressure distribution on its boundaries. By calculating the difference between the current and target pressure distributions, geometric boundaries are modified so that the pressure di...
متن کاملPerformance improvement of a wind turbine blade using a developed inverse design method
The purpose of this study is to improve the aerodynamic performance of wind turbine blades, using the Ball-Spine inverse design method. The inverse design goal is to calculate a geometry corresponds to a given pressure distribution on its boundaries. By calculating the difference between the current and target pressure distributions, geometric boundaries are modified so that the pressure di...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JEEMECS (Journal of Electrical Engineering, Mechatronic and Computer Science)
سال: 2019
ISSN: 2614-4867,2614-4859
DOI: 10.26905/jeemecs.v2i2.3162